Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kevin
December 9, 2017
While installing, the bold wasn't at the proper angle and it pushed the nut and it's harness through the hole and "into" the body of the microwave. Can the replacement nut be installed from the outside of the microwave or do i have to remove the shell and install from within?
For model number KMHS120EWH5
Hello Kevin, Thank you for your inquiry. You should just be able to remove the damper or top and be able to install the nut that way. As a precaution, since microwaves can hold power even when unplugged, we advise you to make sure the capacitor or magnetron is fully discharged by creating a short circuit (direct connection) between the two capacitor terminals and from each terminal to chassis ground (bare metal surface) before attempting the installation. Hope this helps!
3 people found this helpful.
Was this helpful?
Thank you for voting!
David Le
November 22, 2017
The nut. Is this the part that's on top of the the microwave. Where the mounting screw goes in??
For model number KMHC319ESS0
Hi David,
Thank you for your question. Yes, this is the mounting nut for the cabinet. I hope this helps. Thank you and have a great day!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Nick
December 24, 2017
Hi, should there be a total of two of these nuts? The diagram only shows 1 under part #11 but there is clearly two holes and two mounting screws that hold the microwave in place. I only have 1 nut on mine and need to know if i should order another. Thanks!
For model number WMH31017AS4
Hi Nick,
Thank you for your question. If there are 2 mounting holes and 2 screws, then you would need 2 nuts to secure the screws. I hope this helps. Thank you and have a great day!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
