PCB ASSEMBLY,DISPLAY EBR75439402

Hi Jamie, Thank you for the question. The main PCB Assembly has the cycle timer built into it. The PCB assembly will need to be replaced in order to fix this issue, PartSelect Number PS7793220. Hope this helps!

Good Day Kirk. Thank you for your question in regards to your unit (Model Number DLE1101W). Based on our research, you may need to replace one or more of the following parts in order to solve the issue that you are having: 1) Thermal Fuse (PartSelect Number PS3530485). 2) Dryer Thermistor NTC (PartSelect Number PS3529026). 3) Blower Thermostat (PartSelect Number PS8747887). 4) Sensor (PartSelect Number PS3529161). 5) Thermostat Assembly (PartSelect Number PS3530482). 6) Heater Assembly (PartSelect Number PS3527790). You can order these parts either online at our website www.PartSelect.com or by calling us by phone at 888-260-4310. Best Regards.

Hi Tim, thank you for your question. There are a few parts that you could take a look at for this issue. I would suggest checking your thermal fuses and your thermostats. Those might actually be what the issue is. If they are find however then it may have something to do with your board. I hope that helps. Good luck with your repair.

Hello Edward, thank you for your question. This issue could be caused by a bad fuse or thermostat. We would recommend testing the PartSelect Number: PS3530485 thermal fuse, thermostat PartSelect Number: PS3530482 and PartSelect Number: PS8747887 first. Set your multimeter to the R X 1 setting. Take each of your meter's probes and touch one to each terminal. You are testing for continuity, and you should receive a reading of either zero or infinity. At room temperature, testing the thermostat should produce a reading of zero. But if a thermostat is tested when it is heated to its limit, a reading of infinity should be produced. We strongly recommend that you test your thermostat at room temperature. If the test you conduct with your thermostat does not produce these results, then you should replace the component. If the thermostats are not the issue we would recommend testing the main board, and user interface board. I hope this helps!