Turntable Coupler WB06X10420

I tried to install the new part several times, but it didn't work. So I used a pencil to move things around down the shaft. After that the new part went in and now my microwave is doing what I need it to do.

I replaced the turntable motor and coupler. It did not fix the problem. Not sure where to go from here. Looks like the next step involves parts that are as expensive as a new microwave.

I simply removed the broken coupler and snapped the replacement part into place, being careful to line up the slot on the new coupler. Just a note: the troubleshooter guide on the website was a great help in determining how to fix the problem. The comment section let me know this a simple fix anyone could do.

had someone else do it...he advised very easy to accomplish.

Piece did not fit as well as old piece needed to take off a small piece to make it fit. Once it was in the turntable worked again

Removed 5 philip head screws from under panel. Under panel droped down exposing drive motor. Removed one drive motor screw, replaced with new motor at the same time lining up new coupler. Pressed together, reinstalled motor srew, attached wire coupling and tested. Worked fine. Reinstalled lower panel screws (5)and unit was ready to go. I ordered two of each units because I believe this to be weak link in the unit. It was only 2 years old, used little as I have another home. I recently installed a like unit (Hanging) and it was a breez. 4 srews properly placed, electrical cord hole properly drilled & ready to go in 45 minutes.

When I received the part, I popped it in and POW, problem solved. I praise PartSelect, they offered my part at a fantastic price compared to other vendors and shipping time was very good! will use them again when I have the need.

I took the glass table up and underneath was the turntable coupler. I reached in with my hands and gently pulled the old coupler out. Once out I lined up the new one and gently pushed it in the hole until it locked into place. The process took about 5 minutes to complete. Very easy to install.

Pulled off old coupler.It was tight so used a trim bar to remove. Checked motor shaft since there was 2 types available.One, square shaft,other D shaft. Ordered in AM and received the next day in PM by Fedex.. Can`t get much better than that! Pushed on and done......Like new again...

Replaced part with minimum effort.