Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Greg S - April 8, 2019
Verified Purchase
Perfect replacement for 18-year-old dishwasher
The part was in great condition and came quickly. Thanks
★★★★★
★★★★★
Edwin C - January 28, 2019
Verified Purchase
Replaced part
Awesome !
★★★★★
★★★★★
Brenda K - August 19, 2018
Verified Purchase
Easy repair
Handle was easy to replace and saved me a good amount of money
★★★★★
★★★★★
Gary H - June 2, 2018
Verified Purchase
So easy, even I could do it.
The door latch on our dishwasher must have been going out even before we bought the house. It was always hard to open and kept getting harder to open until a piece of plastic broke off in my hand. There were only 2 screws to remove to get the latch off . . . along with 4 electrical plug ins. The new piece went on easily. The dishwasher is even quieter now. I think it's because the latch wasn't pulling the door closely as tight as it should be. Now all is well. Instead of paying the repair guy a quoted $175 for the service call, repair, replace and part . . . I paid only $38. That says it all.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 4.5 / 5.0, 7 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
a part of the latch broke off causing the latch to not secure the door
on a U-TUBE repair sequence it showed removing the entire front panel of the door. With this Kenmore model the front panel is in two parts. The upper part where the controls and latch are is independent of the front panel so all I needed was to unscrew the upper panel, unscrew the latch, pull off the wires and reinstall by plugging in t
... Read morehe wires, screwing the new latch to the door, reinstalling the panel to the door. It took about 15-20 minutes for the entire operation.
Read less
Robert from MIDDLETON, ID
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door Latch Broken
Our dishwasher handle was broken and I stumbled upon PartSelect's YouTube video that described how to change the Latch Assembly while looking for a new dishwasher. It looked easy so I thought that I would give it a try. The hardest part of the installation was finding which circuit breaker shut off the dishwasher. That being said, our dis
... Read morehwasher was slightly different from the model shown in the video. When we unscrewed the screws on the inside of the door the top part of our dishwasher did not come off and fall forward as it did in the video. Our control panel was longer and continued beneath the front panel. We could not access the latch assembly until we removed two small screws near the bottom of the dishwasher door and popped the front panel off. Other than that it was exactly as the video showed. EXCELLENT service. I ordered the part and received it the next day. WOW. I would recommend this website to anyone who needs appliance parts.
Read less
Jodi-Lee L from Boca Raton, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
5 of 7 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
door latch broken
Repair was easy, except had to run to Home Depot to buy a special screw driver to take the handle off. Once this was purchased the repair was fast and simple.
Jan from Tomball, TX
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
1 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Latch was busted
cannot describe because not good at it however I just read what everyone else did and it was a piece of cake.
Todd from Oak Creek, WI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
2 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door handle broke from latch
Removed the 6 screws from top section inside door. Pulled control panel from front side of door. Removed two screws holding latch assemly unit and pulled 4 wires from connection. Attached the 4 wires to new door latch assembly and screwed back into place. Replaced the control panel and attached with 6 screws. Couldn't get any easier.Great
... Read more service Quick delivery.
Read less
Robert from Warren, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
4 of 5 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Latch Broke off and needed replacement
I followed the previous repairers instructions. -Remove the screws around the door panel -Remove the door panel face -disconnect the wires -reconnect wires to the new Latch Assy -tighten the screws and reassemble the door panel.
Arnel from Jersey City, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
4 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No one could open the door, but me.
I took out the four screws that hold the front plate on and removed the latch/switch combo. Two screws hold that on, so i removed them and disconnected tthe wires. Put new assembly in place, reconnected the wires and put it all back together. Case, and door, closed. By the way, getting my part from PartSelect was very easy.
Patrick from Zachary, LA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
10 of 13 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Oscar
December 27, 2021
Dishwasher starts on its on. It can be in the off position, in about 5 mins the selector switch starts turning on it on and dishwasher starts up. Will a bad latch assembly have anything to with it.
For model number fbd2400kb3a
Hello Oscar, Thank you for your inquiry. It could be the door switch, the wiring or the timer. You can test the door switch and timer with a multimeter. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. Check the wiring for any loose connections or damage. Good luck with your repair.
The door handle (black plastic) on our dishwasher is broke. The door will close and the dishwasher will work. The broken handle is sharp and a little dangerous. The front plastic control panel that houses the handle is also starting to crack from forcing the handle/door to open and close. Its been very difficult trying to find the correct part number to order. Can you help?
For model number FFCD2413US2A
Hi Alan, Thank you for writing. The Control Panel for this model is listed as Part #: PS12585711 and the Handle shows to be included with the Panel. We hope this helps!
