This broil element supplies heat for cooking and is located in the roof of an oven. If there is little to no heat when cooking, a damaged element, or food is taking too long to cook, these symptoms could be solved by replacing this part. Before starting this replacement, make sure to unplug your range from the power source or shut off from the house circuit breaker. You will need a Phillips screwdriver to complete this repair. This part comes in a matte black color. For safety reasons, make sure to wear gloves. Refer to the manual provided by the manufacturer.
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Chester
September 10, 2017
The broiler on my built-in oven does not heat. I suspect it is the element however, since i will be repairing the oven myself i need advice. What is the probability of my problem being a bad broil element? Because it is an expensive part, please provide me with some troubleshooting procedures. Additionally, could i remove the broil element and test for continuity or specific resistance? I have verified that i am following the operation instructions completely to no avail. Thank you
For model number FEB24S2ABB
Hi Chester,
Thank you for your inquiry. You can test this part with a multi-meter. If your element is reading between 0 - 50 ohms, then your broil element has continuity. In most cases it is the broil element that is the issue. However testing it will be able to tell you whether or not it is the broil element that is the issue. Good luck with your repair.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Jim
February 24, 2020
How to remove the broiler element after removing the 2 phillips screws
For model number FEB27S5ABB
Hello and thank you for writing.
Once the screws are removed entirely you should be able to just remove the element towards you then unplug both terminals and replace it with the new one by securing it back with the screws. Careful with the new element so you do not damage it by bending or forcing it in place.
For your convenience, we have attached the link to our repair video. We hope this helps. Good luck with your repair.
https://www.youtube.com/watch?v=KwKOazwYuJE
We hope this helps. Please contact us anytime if you require further assistance.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Cindy
December 27, 2021
How hard is it to replace the broil elements
For model number PLEB27T8CCB
Hello Cindy, Thank you for the question. Most customers have been able to perform the repair on their own. Make sure to unplug your range from the power source or shut off from the house circuit breaker. You will need a Phillips screwdriver to complete this repair. We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
