Quick Question!

Have you ever purchased from PartSelect.com before?

417655-1-S-Frigidaire-131382402         -Idler Pulley Assembly
417655-1-S-Frigidaire-131382402         -Idler Pulley Assembly 417655-2-S-Frigidaire-131382402         -Idler Pulley Assembly 417655-3-S-Frigidaire-131382402         -Idler Pulley Assembly https://www.partselect.com/Schematics/Frigidaire/P901164G.gif

Idler Pulley Assembly

Your Price

PartSelect Number PS417655
Manufacturer Part Number 131382402
Manufactured by Frigidaire

Use this double idler pulley assembly with tension spring with a reversing motor.

This part works with the following brands: Frigidaire, Kenmore.

This part works with the following products: Dryer, Washer Dryer Combo.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.0 / 5.0, 1 reviews What's this?
1-1 of 1

23 of 650 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: More than 2 hours
Tools: Nutdriver, Screw drivers, Socket set

Dryer making noise, discoloring clother and eventually stopped turning

Unplugged dryer. Removed top of dryer. Removed front panel. Remove small access to belt in back panel and note belt configuration thru pullies. Removed plastic guide on front frame, 1 screw. Removed belt. Removed Drum. Lift up drum to release from bearing assembly bracket in back. Small bearing was missing. Removed rear bearing assembly brackets. Removed idler pully assembly, one bolt. Thoroughly vacuum and clean. Scrape off felt on front panel and clean well. Glue on front top of front panel and clamp new felt and guides in place. Replace bearing bracket in rear being careful to replace the small bearing that was missing. I used my laptop to guide me. I had your schematic diagram up on the lap top to make sure I put it back together correctly. Replaced Idler Pully Assemply. 1 bolt.
Unscrew old plate and large ball from back of dryer by unscrewing 3 screws from inside drum. Replace with new part and screws. Put drum back in place and insert in bracket in back. Remove clamps from felt and guides. Put belt in place. Replace palstic guide on front frame one screw. Close front panel. From back access panel thread belt thru pullies. Close back panel. Close top. Allow glue to dry. 2 hours. Test. OK. Allow glue to set 24 hours. Dryer works great. OH yeah. Plug back in..

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-1 of 1