Thermostat

Hi George, thank you for your question. Looking at your model information there are a few parts that you should take out and test to see which one is giving you the issue. The first parts to check in this case would be all of your thermostats and thermal fuses. You can test those parts with a multi meter and they should be reading 0 ohms to be working correctly. If those parts are fine, you should then go on to testing your heating element as well. You can also test that with a multi meter and it should be reading between 0 - 50 ohms. Something else you should also check would be your filter and ducts. Make sure there is absolutely no blockage that would restrict air flow in your appliance. I hope that helps. Good luck with your repair.

Hi Lorenzo, Thank you for your inquiry. The most common parts that will fix this issue are the sensor, the thermostat and the thermistor. To verify which part is causing the issue you will need to use a multimeter to check the continuity on them. I hope this helps. Thank you and have a great day!

Hello Robert thank you for writing . Normally you would remove the top panel which should have 3 philips screws on the back. Once you lift the panel up the ignitor is exposed for replacement. Hope this helps. Contact us anytime.

Hello and thank you for writing. It certainly sounds like it could be a faulty temperature sensor PS3529161 and/or possibly a malfunctioning thermostat PS3529026you should check the part(s) for signs of damage or test with a multimeter, and replace the part(s) as needed. We hope this helps. Please contact us anytime if you require further assistance.