Switch,Micro

Hi Steve, Thank you for your question. The issue could be the micro switch in the dispenser. The dispenser micro switch is a momentary contact switch that when activated it will supply power to the auger motor and the solenoid for the dispenser door. The switch sits behind the pad or lever that is pressed to dispense ice. You will need to remove power to the appliance and then remove the control panel cover to access the switch. You can check the continuity of the switch with a multi-meter. If the switch checks out fine, you will need to check the dispenser control board and the dispenser actuator. I hope this helps. Thank you and have a great day!

Hello Mark, thank you for your question. If the ice lever itself has broken, all you should need to replace is the lever itself, part number ABH74219702. I would also recommend checking the Dispenser Funnel Guide MDR62062701 and the Dispenser Front Panel MCK66542801 to be sure that the parts the lever attaches to are not broken as well. I hope this helps!

Hello Malie, thank you for contacting us. The switch, part number PS3529276, is a dispenser switch. The descriptions given are generic. Based on the model, the switch can be used for both the ice and the water dispenser switches. We hope this helps.

Hi Stephen, thank you for your question. Looking at your model information you would have to remove the entire dispenser housing to do that. To do that you would need a flat tool or a putty knife so that you could pop it out of place. There are little tabs all around the perimeter that hold it in. If you use a putty knife I would suggest taking a piece of masking tap to dull the edge a bit. That may help protect your appliance from any scratching. Once you have that dispenser housing off, the switches would be right there behind it for you to change out. I hope that helps. Good luck with your repair.

Hello Joanne, Thank you for the question. the most commonly replaced part for the ice dispenser not dispensing is the Manufacturer Part Number 6600JB3001F, but I suggest testing both switches with a multi meter. Thank you for your inquiry, good luck with this repair!

Hi Gary, Thank you for your question. If there is water overflowing the ice cube tray, check the water inlet valve to see if it is malfunctioning. If a component in the valve has failed, it may cause the water to continue to run. Also, a water inlet valve requires a minimum of 20 psi to work properly. If the water pressure is too low, the valve may not close fully when the power is shut off and this will cause the water to overflow. We hope this helps. Thank you and have a great day!

Hello Margie and thanks for writing. It certainly sounds like a faulty bucket assembly PS11709701 you should check for signs of damage, and replace it if needed. We hope this helps. Please contact us anytime.

Hello Yvonne, Thank you for your question. The 4 lead wire is only available by buying the PCB display assembly under part PS3646208 for your model, since the wires are not available separately. We hope this helps.

Hi Andrew, Thank you for your question. The part number listed under your model number for the micro switch which is used for the ice maker and the ice dispenser is PS3529276. If you need help placing an order for it, customer service is open 7 days a week and anyone will be happy to assist you. Please feel free to give us a call. We look forward to hearing from you!

Hello Maria, thank you for your question. According to our research, the issue is probably with the Auger Motor, part number PS11761129. Customer service is available 7 days a week if you need help placing an order. Glad to be of assistance!