Switch,Micro 6600JB3001C

Hi Steve, Thank you for your question. The issue could be the micro switch in the dispenser. The dispenser micro switch is a momentary contact switch that when activated it will supply power to the auger motor and the solenoid for the dispenser door. The switch sits behind the pad or lever that is pressed to dispense ice. You will need to remove power to the appliance and then remove the control panel cover to access the switch. You can check the continuity of the switch with a multi-meter. If the switch checks out fine, you will need to check the dispenser control board and the dispenser actuator. I hope this helps. Thank you and have a great day!

Hello Mark, thank you for your question. If the ice lever itself has broken, all you should need to replace is the lever itself, part number ABH74219702. I would also recommend checking the Dispenser Funnel Guide MDR62062701 and the Dispenser Front Panel MCK66542801 to be sure that the parts the lever attaches to are not broken as well. I hope this helps!

Hi Mark, thank you for getting in touch. Based on our research, the issue is most probably with the display control board, part number PS11761185. We would suggest replacing it to solve the problem. Glad to be of help!

Hello Malie, thank you for contacting us. The switch, part number PS3529276, is a dispenser switch. The descriptions given are generic. Based on the model, the switch can be used for both the ice and the water dispenser switches. We hope this helps.

Hello Eugene, thank you for your inquiry. According to our research, the issue does not seem to be with the dispenser switch. If the water filter was just replaced or installed, ensure the filter was installed correctly. If the water filter is not seated properly, it can cause no or low ice production. Also, it is possible that the water line was not completely purged and there was still air in the system. This will allow water to drip through the fill tub going to the icemaker, causing the fill tube to freeze. Use a hair dryer to thaw out the fill tube that fills the icemaker up with water so that water can go through the tube and make it into the icemaker. We hope this information helps!

Hi Stephen, thank you for your question. Looking at your model information you would have to remove the entire dispenser housing to do that. To do that you would need a flat tool or a putty knife so that you could pop it out of place. There are little tabs all around the perimeter that hold it in. If you use a putty knife I would suggest taking a piece of masking tap to dull the edge a bit. That may help protect your appliance from any scratching. Once you have that dispenser housing off, the switches would be right there behind it for you to change out. I hope that helps. Good luck with your repair.

Hello Joanne, Thank you for the question. the most commonly replaced part for the ice dispenser not dispensing is the Manufacturer Part Number 6600JB3001F, but I suggest testing both switches with a multi meter. Thank you for your inquiry, good luck with this repair!

Hi Gary, Thank you for your question. If there is water overflowing the ice cube tray, check the water inlet valve to see if it is malfunctioning. If a component in the valve has failed, it may cause the water to continue to run. Also, a water inlet valve requires a minimum of 20 psi to work properly. If the water pressure is too low, the valve may not close fully when the power is shut off and this will cause the water to overflow. We hope this helps. Thank you and have a great day!

Hello Margie and thanks for writing. It certainly sounds like a faulty bucket assembly PS11709701 you should check for signs of damage, and replace it if needed. We hope this helps. Please contact us anytime.

Hello Yvonne, Thank you for your question. The 4 lead wire is only available by buying the PCB display assembly under part PS3646208 for your model, since the wires are not available separately. We hope this helps.