Switch Assembly,Sensor 6501EA1001R

Hello Salvador, thank you for your question. – Check for a loose wire harness, a damaged wire harness, or a burnt faulty wire. – Check that you get continuity through the wire harness by checking it with a multimeter. – If the wire harness from the water level pressure sensor to the main control board is found to be faulty, replace it. – If you get continuity and the wiring harness is securely connected to both the water level pressure sensor and the main control board If all the wires are tested and the connections are solid, the issue may be the electronic control board. I hope this helps!

Hi Scott, thank you for your question. Yes, this would be the pressure switch. I hope that helps. Good luck with your repair.

Hello David, thank you for your question. The most likely issue is either the water valve itself. We would recommend replacing that water valve first. If that doesn't fix the issue the electronic control board should be replaced. I hope this helps!

Hello Wanda, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS3644957 for the Lid Switch. Hope this helps, good luck with this repair!

Hello Ed, Thank you for the question. This is normally caused buy a defective Pressure Switch, PartSelect Number PS3529177. Before replacing the switch, we suggest removing the Pressure Hose to the Switch to make sure there is no build up preventing the water to reach the switch to active it. We hope this helps!

Hello John, Thank you for the question. The most common cause is a defective Inlet Water Valve, PartSelect Number: PS12374721. The valve can become stuck open and allow water to flow into the tub when not in use. Hope this helps, good luck with this repair!

Good Day Lib. Thank you for your question in regards to your unit (Model Number WFSL1532EK). Unfortunately we not able to find a parts list for the model number you provided to us. We believe that this may be because that the unit is still under warranty and one has not been released yet by the manufacturer. We would recommend reaching out to the manufacturer for further assistance. Best Regards.

Hello and thank you for writing. It is possible that whoever hooked up your unit reversed the hot and cold water hoses. If this does not fix this problem then your Switch sensor PS3529177 indeed might be faulty and possibly needs to be replaced. We hope this helps. Please contact us anytime.

Hello Wes, Thank you for the question. Normally this is caused by a bad cycle timer. The timer for this model is built into part of the Main PCB Assembly. We hope this helps!

Hi Victoria, Thank you for your question. The LE error code is letting you know that there is a communication error between the washer motor and the control panel. To clear the error code you will need to reset your washer. Unplug your washer and press and then press and hold the "Start/Pause" button for f seconds. Once you have done this, plug the washer back in. We hope this helps! Good luck with the repair!