Electronic Control Board 241973711

Hi Wesley, Thank you for your inquiry. If you are getting the error code 5YCF then you will need to replace both the the main electronic control board at the bottom of the refrigerator in the back as well as the control board in the dispenser. I hope this helps. Thank you and have a great day!

Hi Ted, Thank you for sending in your question. SY CE error code, this means there is a communications issue. This communication problem is caused by either a wiring issue, wire harness issue or faulty control board. I would start with checking to making sure the wiring is all intact and the wire harness that plugs into the control board did not come lose. If everything appears good with the wiring then you will need to replace the control board. When replacing the control board you now have to also replace the Power Board down at the bottom of the appliance behind the kick plate. The manufacture has made some changes to the parts and in order for them board to work they both need to be replaced. When removing the display trim to access the display board, use a thin plastic scraper to pry the trim off until the clips pop loose and release the trim and expose the board. Hope this helps!

Hello Jaime, thank you for writing. Part 241973702 was replaced by 241973711. It is the correct replacement for your model. Replacement parts are sometimes updated by the manufacturer and may be different in appearance but will have the same functionality. We hope this helps.

Hi Anthony, Thank you for your question. If the freezer section is too warm the electronic control board is one part that you will need to check. Some other parts that you will need to check are the evaporator fan motor and fan blade, the filter-drier, the sensor and the defrost thermostat. I hope this helps. Thank you and have a great day!

Hello Stephen, Thank you for the question. This sounds like an issue with a defective Electronic Control Board, PartSelect Number PS3503319. Hope this helps!

Hello Raymond, Thank you for the question. The Error Code SY CE is a Communication error during powering up. This indicates a problem with wiring to and from the main control board and the user interface board. If the parts have been replaced, I suggest checking the wiring. Hope this helps!

Hello Francine, thank you for asking. We recommend testing the Power Board PS8689427 as well as the Electronic Control Board PS3503319. We have a video on how to use a multimeter to test your electronics.

Hi Ken, Thank you for the question. Soudns like you are looking for the Main Power Board, PartSelect Number PS3419800. Hope this helps!

Hi Mike, Thank you for your question. There are a couple of parts that you should check first. I would suggest checking your ice solenoid assembly. Then checking your module dispenser as well. If both of those parts are fine, it may be your board that is the issue. You can test your solenoid with a multi meter to be sure it is functioning correctly. I hope that helps. Good luck with your repair.

Hello Dusten, thank you for your question. If you can make the different selections on the control panel but the unit will only dispense crushed the issue could be the solenoid PartSelect Number: PS8691994. If you are unable to select cubed on the control panel the electronic control board PartSelect Number: PS3503319 should be replaced. I hope this helps.