Agitator Kit

Hello Chris, Thank you for contacting us. I have researched the model you have provided and have found the part you’re looking for is PartSelect #: PS1488027. Hope this helps!

Hello Tom, Thank you for your inquiry. You need to start by removing the cap, the cap barrier, and use a socket wrench to remove the bolt from the agitator. You should then be able to pull the agitator out. We have included a link to our video for a similar agitator to assist you with removing the agitator. Hope this helps.

Hi Jamal, thank you for your question. There are a few parts that you will have to check to see if they need to be replaced. You should check your thrust spacer and agitator cam bearing. Both of those parts are in the agitator repair kit. You may also want to take a look at your agitator cams, your gearcase, and then finally your motor itself. I hope that helps. Good luck with your repair.

Hi Eric, Thank you for your question. The kit includes the bottom base, the agitator dogs, the cap and the agitator mover. I hope this helps. Thank you and have a great day!

Hello Chris, Thank you for contacting us. I have researched the model you have provided and have found the part you’re looking for is PartSelect #: PS1488027. Hope this helps!

Hello Robert and thank you for writing. Softener dispenser. This part is discontinued for your model and is no longer available. We have no known replacement information in our system. We recommend you contact the manufacturer of the part to see if they have recently released a new substitute. We do carry related parts for units just like yours. For example, part number PS11749935 Good luck with your repair.

Hi Michael, Thank you for your question. We have included a link to one of our YouTube videos that you may reference on how to install the agitator. The washer in the video may appear different from yours, but it will give you a general idea on how to install the part. If you have any questions, please let us know. We are open 7 days a week. We look forward to hearing from you!

Hello Leroy, thank you for reaching out. We have researched your model and would recommend checking the following parts to fix your issue: agitator directional cogs, part number PS388034, agitator repair kit, part number PS334650, drive motor coupling, part number PS1485646, and upper agitator, part number PS11741159. Please reach out to customer service if you need help placing an order. Glad to be of help!

Hello, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is Agitator Bold PartSelect Number PS10067065 and it has right hand threads. Hope this helps.

Hello Debra, thank you for your question. If the washer is not spin drying your clothes make sure the drain hose is not bent and restricting water from draining out. It is also a good idea to remove the hose from the drain pump and check the pump and drain hose for any blockages. Your washer has a filtering device down and near the pump called a drain filter, check this filter for debris. You can test the drain pump with a multimeter. Unplug the appliance from the electrical outlet before you begin. Touch a probe to each of the terminals on the pump. A reading of zero or infinity, means the pump requires replacement. Part number: PS11741239. It could also be the timer. Part number: PS11746373. Touch the two probes of the volt-ohm meter to the contact points to be tested. Turn the dial of the timer to the appropriate cycle that is being tested. There should be no continuity reading on the volt-ohm meter during the test. If there is a reading on the volt-ohm meter, the timer is faulty. Good luck with your repair!