Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
November 5, 2018
Igniter does not get hot, igniter and fuse have both been replaced and both check out ok
For model number mgdc200xw2
Hello Dennis, Thank you for the question. I suggest checking the Internal-Bias Internal-Bias, PartSelect Number PS11741405. The thermostat can be tested. Set your multimeter to the R X 1 setting. Take each of your meter's probes and touch one to each terminal. You are testing for continuity, and you should receive a reading of either zero or infinity. At room temperature, testing the thermostat should produce a reading of zero. But if a thermostat is tested when it is heated to its limit, a reading of infinity should be produced. We strongly recommend that you test your thermostat at room temperature. If the test you conduct with your thermostat does not produce these results, then you should replace the component. I hope this helps.
This dryer seems to still work ok except that the application of heat seems to be hit or miss. The heat works sometimes and does not other times.I like the dryer and will consider replacing parts in order to keep it.
For model number LG6881XSW1
Hello Chris and thank you for writing.
It certainly sounds like a faulty thermal fuse PS11741460 and /or coils PS334310, you should check for signs of damage, and replace it if needed. It is recommended to replace both parts at the same time. We hope this helps. Please contact us anytime.
The problem with my dryer it needs for a long time before it everything is dry. I checked the continuity thermal fuse, dry igniter, gas valve solenoid (still can be faulty), radiant flame sensor and thermal cut-off fuse. Only thing left is the gas value.
For model number LGR7645JQ0
Hello Thivakaran, Thank you for the question. Locate the M Series New Style Coil Kit and test them using a multimeter, if you get a resistance reading on the meter of 1000-2000 ohms, the coil is bad and must be replaced. We hope this helps!
When the igniter reaches a high enough temperature, these coils (Coil Valve, Dryer Gas Valve Coil Kit, Dryer Valve Coil Kit, Gas Valve Solenoid) work together to open the gas valve and allow the gas to enter the burner. ...