Thermal Cut-Off Kit 279816

Hi Kyle, your diagnosis is correct. This assembly 279816 is what you will need to repair your dryer, and it is the right part for your model. Best of luck with this repair.

Hello Steve, thank you for your question. I would recommend replacing the Thermal Cut-Off Kit part number 279816. The thermal cut-off turns off the heating component when the dryer overheats, ensuring there is a consistent level of heat at all times. If the unit isn't cycling off properly, the unit will get too hot. I hope this helps!

Hi Dion, Thank you for the great question. The first part we suggest you replace is the Thermal Fuse. This thermal fuse is designed for use in dryers. It is a safety mechanism that stops the flow of electricity to the heating element when a dryer overheats. When this fuse is faulty, your dryer will not start or it will not heat properly and shuts off to soon. This is a one-time fuse, meaning it cannot be re-set, It must be replaced. Hope this helps!

Hi Micha, we recommend first disconnecting the wires to the heater and checking them for 240 volts across both. If you do not have the 240, you need to find where you are losing the rest. I hope this helps.

Hi Kim, Thank you for your question. Yes, you would have to replace that part if there is no continuity. Good luck with your repair.

Hello Jonathan, the order of the wiring from your motor should go to the heater, then to the thermal cut off, and from there to the high limit, and then to the timer. Please let us know if you have any further questions.

Hello Larry, Thanks for your question. You will want a multimeter to test a few different internal parts. Replace any that do not show electrical continuity. Also be sure to clean out the venting if that is clogged. Test the internal-bias thermostat, the thermal fuse, the high-limit thermostat, and the heating element. Visually inspect the belt as well for any signs of wear and tear. I hope this helps.

Hello Brian, thank you for your question. The issue is most likely with a thermostat. There are a few thermostats in the unit. With a multimeter, these parts can be tested very easily. The parts you will want to check are Thermostat, Internal-Bias Part Number: WP3387134, Thermal Cut-Off Kit Part Number: 279816 and Thermostat, High Limit 221 F ( Part Number: WP3977767. Set your multimeter to the R X 1 setting. Take each of your meter's probes and touch one to each terminal. You are testing for continuity, and you should receive a reading of either zero or infinity. At room temperature, testing the thermostat should produce a reading of zero. But if a thermostat is tested when it is heated to its limit, a reading of infinity should be produced. We strongly recommend that you test your thermostat at room temperature. If the test you conduct with your thermostat does not produce these results, then you should replace the component. I hope this helps. Thank you and have a great day!

Hello Jenny, thank you for your question. Unfortunately, that cut off kit will not work with your model number. The Thermal Cut-Off Kit for your model is part number 279769. There is an installation video on our site on how to install that kit. Please enter the part number into the site for current price and availability. Good luck with your repair!

Hello Wes, Thank you for your inquiry. We would recommend checking the following parts to fix your issue: blower wheel, moisture sensor, lint filter, drum seal, lint chute seal, and front seal. Also make sure that the air flow is not constricted in any way. Hope this helps!