Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
VL
August 30, 2017
How do I disconnect the electric inside the freezer to change the fan?
For model number TBT18NABNRAA
Hi VL,
Thank you for your inquiry. You should be able to just unplug the connections from the fan to the wire harness. I hope this helps. Good luck with your repair.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Uy-Loi Ly
March 31, 2018
Water accumulates inside to bottom of refrigerator drawer.
For model number TBX18DAXPRWW
Hello Uy-Loi, Thank you for your inquiry. Check with checking the drain funnel, drain hose and grommet at the back of the fridge to see if they are cracked, frozen or clogged. Check the door gaskets for any leaks. You can also test the water inlet valve, your ice maker (if your fridge has one), and your water lines. Hope this helps!
2 people found this helpful.
Was this helpful?
Thank you for voting!
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Customer Repair Stories
Average Repair Rating: 4.5 / 5.0, 6 reviews.
What's this?
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Noisey fan/motor (bad motor bearing ?)
Removed 2 phillips head screws to remove ice maker (could have just loosened them) Pulled fan off of shaft Removed 2 phillips head screws on motor bracket , disconnected three motor wires & removed motor. reversed process to install new motor & fan blade. Space was a little tight for two hand and arms, but do-able.
MAKE SURE YOU UNPLUG THE REFRIGERATOR BEFORE WORKING ON EQUIPMENT
Removed ice tray. Removed bottom cover, 2 screws. Removed center cover, 2 screws. Removed backside cover, 4 screws. Removed fan assembly from back wall, 2 screws. Disconnected wires from defective motor, old fan blade was cracked spinning freely on shaft.
Reversed the order for re-assembly. Plugged in refrigerator, now working great.
Make sure you buy the rubber grommets that supports the motor, I did not and did not notice the old ones were worn out. A vibration is coming from the new motor after repair because I used the old grommets. These should be included with the new motor.
Unplugged frige, removed top shelf, pulled broken fan blade off. Replaced with fan blade just purchased from PartSelect. Very simple repair. Orderd and recieved the right part.
