This part is the replacement water line for your refrigerator. It is a long plastic tube, which is 5/16 of an inch in diameter. If your refrigerator is leaking, or will not dispense water or ice, you may have a damaged water line. When you replace the water line, you may want to pick up a new water tube union as well. You can use a utility knife to cut the old water line where it is damaged, and use the union to attach the new water line to the old one. This tubing is sold individually and is an OEM part.
How Buying OEM Parts Can Save You Time and Money
Part Videos
Replacing your General Electric Refrigerator Plastic Tubing - 5/16 Inch
Average Repair Rating: 3.4 / 5.0, 16 reviews.
What's this?
Sort by:
< Prev
1
2
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Water line was leaking
The internal water line was leaking. I could not find any repair parts for my refrigerator but the GE 5/16 water line was the same size. I purchased 6' of tubing and two unions. Make sure the clean and square. If possible, make the cuts in a spot where you can use the pliers and wrench to tighten the union. I cut approximately 2' out of t
... Read morehe existing line and replaced it with the same length of new line using the 2 unions, one on each end. Took about 5 minutes.
Water tubing lines runs very close the compressor. Over time the heat caused the line to become brittle. Result was broken line and lots of water under the unit.
Cut the line inside the regiferator behind the bin and used the tube union to attach new 5/16" tubing to run to the solenoid valve assy in the back of the refigerator. Location of the valve assy makes connecting very difficult. But was able to complete repairs.
Water line was broken at the bottom of the freezer door.
There is no access to the inside of the door to replace the water line. I was able to insert a 1/4" drip line barbed connector into the old line at the base of the door and then connect that to a piece of the plastic tubing which I then connected back to the original water supply tubing with the 5/16" union. It took three attempts to get
... Read more the tubing through the bottom hinge without a crimp in it. It's best to have a second person to hold the door while you "fish" the tubing through the hinge.
I never would have attempted the repair as all my research indicated that I would have to take the stainless steel door off to replace the ice maker solenoid that shuts the ice chute door. But on your site someone (bless them)wrote that you could get at the solenoid by popping off the electronic selector panel. They are on the underside
... Read more of the dispenser and not at all visible. And your video helped too. Thanks.
This part (plastic tubing) does not show up under my model of refrig...so I had to look thru the various water lines and pick the one that "looked" right. Luckily, this is the exact replacement part and works perfectly. I removed the lower back panel from the fridge, removed the bracket holding the water line connectors and pressed the
... Read moreouter ring of the coupler up until it released the old water line. I pushed in the new line, made sure it was snug with a gentle pull and ran the line under the fridge up to the existing coupler. I removed the old line from the existing coupler under the front left of the freezer door, and pushed in the new line. I did not need to use the new coupler. If my old line would not have been so brittle and cracked in several places, I could have just cut out the leaking portion and popped the new couple in to mend the line back together. Easy job and we can stop buying bottled water at the store now!
Broken water line near solonoid to feed drinking water
bought an push in, in line connector and a new 5/16 plastic hose. I just replaces 2 feet of plastic hose from the selonid up an splices the hose using the connector. Worked perfect.
Water was leaking from back of fridge. Not able to use icemaker
This problem had already occurred in 2008. Repairman replaced dual water valve. Cost $190.00. We decided to do it ourselves this time. The repairs were actually made in three phases. First, when I pulled the fridge out from the wall, unplugged it, and turned the water valve back on I discovered that the plastic tubing from water supply
... Read more into the fridge had long cracks in it and water was spraying out everywhere. I turned water off, went to Lowe's and bought the kit for that repair. Of course I didn't have to use all of the parts in the kit because the water supply was already there from the valve that came up through the floor. After turning the water back on and plugging the fridge back in, my husband and I tested it by trying the water dispenser. We found that water was leaking from somewhere inside the fridge, but didn't know where. After UNPLUGGING it, and turning the water off again, I took the metal back off at the bottom. It was leaking from the bigger plastic tubing (5/16"). It was just hanging, not connected into the dual water valve. Figured it had just broken. So I thought I just needed 5/16" tubing. I went on the GE website and it was very hard to get answers to my problem because I couldn't find the plastic tubing that it looked like. I ended up ordering the plastic tubing that goes up that back of the fridge to the icemaker. They sent me two of those, not one for the freezer and the bigger clear one (5/16") that I thought I needed. Then, I found this website! This PartSelect website is great!! After reading about other consumer repairs, I knew how to disconnect the dual water valve and found out that the smaller plastic tubing that goes up the back of the fridge to the icemaker had been pinched where it connects to the dual water value, barley hanging on. Just quick disconnected it from the valve by pushing up on the outside where the tubing comes out while pulling on the tubing. It came out, and I had to use needle nose pliers to pull some of it out where it had broken off inside. Then, pushed the new tubing into the valve and ran it up the back of the fridge, unscrewed the plate that goes over the clamp that holds the tubing, loosened the clamp a little, pulled the old tubing out, pushed the new tubing in, (the clamp was still tight enough) put the metal plate back on and replaced the screws. Then I re-connected the dual water valve to the electric clips, connected the 5/16" tubing to the right side of the valve. (The black tubing that goes up the back of the fridge goes into the left side of the valve.) put it back into place and screwed it back against the body of the fridge where it goes, put the back on and plugged it back in. We tested it again, and water was leaking, but not from where I made my first repair. I reversed everything again, and discovered that where the 5/16" tubing goes into the dual water value, it seemed more loose than it should have been. That is where the water was leaking from! I ordered the dual water valve, the 5/16" plastic tubing and the water tube union. I replaced the dual water valve-very easy! MAKE SURE YOU UNPLUG THE FRIDGE, turn the water supply off, disconnect the small tubing from the dual water valve, disconnect the electric connections to the valve, and reverse the process. What I did was replace the 5/16" tubing the comes out of valve & goes up into the storage tank behind crisper drawer. Used union there. Put everything back together and it works!!
This repair was done on a 13 year old fridge. Within the last several years I had to replace the Incoming Water Line twice, the line from the Inlet Water Valve to the Dispenser Water Reservoir, and this time the Icemaker Water line. These were all due to the plastic tubing hardening and becoming brittle from the heat of the compressor.
... Read more /> For this repair, I not only replaced the cracked Icemaker Line, I replaced the Incoming Water Line with copper, and replaced the Dispenser Water Reservoir. If you have a leak in one of the plastic water lines around the Valve Assembly, I recommend you do the same.
The Icemaker Water Line instructions from Stephen from Raleigh was very helful and complete.
I found Scot from Fort Collin's instructions on replacing the Reservoir very helpful too. Although I found his comment that one line was too short, to not be the case. In fact I had to trim both lines because they were too long.
Scott from South Lake Tahoe's suggestion to use the old Reservoir Lines to fish the new ones is good. I used duct tape to attach them together instead of drip irrigation fittings, and it worked fine. It helps to have somebody at the back of the fridge to pull the line while you push it from inside the fridge.
The line to the door connection can be accessed by removing the grill at the bottom of the front of the fridge.
Pretty easy repair. Thanks to the other contributors for the help!
Ask our experts a question about this part and we'll get back to you as soon as possible!
5 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
M
February 20, 2018
How to replase water line inside the door
For model number gse25hmhbhes
Hello, thank you for your question. We have an installation video that might help you with this repair. The appliance, and parts that are being use might be different than yours but the overall installation process should be almost identical. I hope this helps!
https://www.youtube.com/watch?v=lnEV4ZHC_W4
3 people found this helpful.
Was this helpful?
Thank you for voting!
Christian
September 5, 2022
I've replaced the 5/16 tubing at the base of the left rear due to a cracked tube.
That lasted for months now it seems the water is leaking from above that where I can't get to it from the rear. How do I get above it to fix the pin leak
For model number Pss26sgpass
Hello Christian, Thank you for your inquiry. This tubing is actually attached to the water tank assembly and you access that from the inside of the back of the refrigerator compartment. We have included a link to our video that shows how to access this part. Good luck with your repair.
I fixed the water line that was broken on our GE frig. When i plugged the line back into the inlet valve it leaked at the point where the water line goes into the valve where it was not leaking before. The attachment is the push in on the valve to receive the water line and the line is pushed in up to the black line. Do you have an idea why this would leak here now when it wasn't before we took the line out to repair it at another spot?
Hi Barry,
Thank you for your question. What I would suggest is turning the water off to the refrigerator and removing the water tube to see if the part of the tube was damaged when it was placed back into the water inlet valve. I would also inspect the area inside the water inlet valve to see if anything is loose or broken. Also test the water inlet valve with a multimeter to see if it working correctly. Depending on your part, your readings can be from 200 and 500 ohms, or for refrigerators with both a water and ice dispenser, the ohms of resistance might be higher, 500 – 1500 ohms of resistance. I hope this helps. Thank you and have a great day!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Frank
February 16, 2018
Water is leaking from filter housing where the water tubes connect
For model number GD2SHAXKT01
Hello Frank, Thank you for your inquiry. I would check the water filter housing fittings (which are part of the housing part# WP2186443) for any cracks. Also check the tubing itself for any cracks or clogs. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Henry
September 24, 2019
How do replace water line in the freezer door
For model number GSS25QGTAWW
Hello Henry, Thank you for the question. Here is a how to video that may help. Good luck with the repair!
https://www.youtube.com/watch?v=u069bgnLrKM
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
