284777-1-M-GE-WR02X10322 -Dust Cap
Part Location Diagram of WR02X10322 GE Dust Cap
See part 607 in the diagram
284777-1-S-GE-WR02X10322 -Dust Cap 360 view
( Grid squares measure 1x1 inch )
284777-1-S-GE-WR02X10322 -Dust Cap 284777-2-S-GE-WR02X10322 -Dust Cap 284777-3-S-GE-WR02X10322 -Dust Cap 284777-1-S-GE-WR02X10322 -Dust Cap 360 view
Part Location Diagram of WR02X10322 GE Dust Cap
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

customerservice@partselect.com

Dust Cap WR02X10322

Rated by 6 customers 

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

$ 16.69
  In Stock
Get FREE EconoShip on orders over $100! T&C apply

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

PartSelect Number PS284777
Manufacturer Part Number WR02X10322
Manufactured by GE
Troubleshooting
This part fixes the following symptoms:
Noisy
This part works with the following products:
Refrigerator, Freezer.
This part works with the following products:
General Electric, Hotpoint, Kenmore.
Part# WR02X10322 replaces these:
AP3414537, 878892, WR02X10360, WR2X10322, WR2X10360
Back to Top
Customer Repair Stories
 Average Repair Rating: 3.2 / 5.0, 6 reviews. What's this?
Sort by:
  • 1
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Noisey Compressor Cooling Fan
Wow, end result was amazing. I had to place my ear close to the refrigerator to find out if the fan was working. So quiet. Prior to this we could hear it in the bedroom. I replaced the fan motor, blade, grommets, i.e. the whole fan train. There were two screws holding the fan which were removed. (After removing the back panel.) Then removed the old blade and dust cap. Detached the wiring harness at the junction. Then reassemble in the reverse order. I screwed up the 1st time...installed the front motor grommet in reverse. Fan blade was not centered. Resulted in a few mins rework. Actually spent more time cleaning all the dust from the compartment and behind the refer than it took to install the new fan system. Did I say that I couldn't be more pleased with the no noise result?
Read less
Other Parts Used:
Condenser Fan Motor Condenser Fan Blade Condenser Fan Blade Compression Ring Dust Cap Evaporator/Condensor Fan Grommet
  • Robert from TUCSON, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver
5 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
High pitch noise
My GE refrigerator emitted high pitch noise a short while ago. I tried different dampening methods that helped but not eliminating the problem. I finally replaced the fan, motor, and associated parts and solved the problem. The total cost was about $50.
Other Parts Used:
EVAPORATOR FAN BLADE Compression Ring Evaporator Fan Grommet - Grey Dust Cap
  • Bert from Audubon, PA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver
15 of 24 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Motor vibration
I pulled the inside cover in the freezer off, pulled the motor out of the bracket, replaced the fan blade , motor, and grommet and that was pretty much it. Very easy to replace. Parts select was fast and had the cheapest price available.
Thanks
Steven Roffey
Other Parts Used:
Evaporator Fan Motor - 115V 60Hz Evaporator Fan Blade Compression Ring Evaporator Fan Grommet - Grey Dust Cap
  • Steven from Columbus, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
17 of 23 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Loud high pitch whining noise behind freezer
Ref. still worked but had this loud high pitch whining noise coming from inside freezer for a few months. It's probably a bad bearing or motor.

1) Remove all shelves and ice dispencer
2) Remove (x2 screws / a green wire that's clipped on) and the evap cover
3) Remove (x3 screws) cover motor/solenoid and unplug harness
3) Remove (x2 screws) icemaker and unplug harness
4) Remove/Loosen (x2 screws bottom / x2 screws top) Duct air freezer
5) Remove (x2 screws) Orifice evap fan and unplug harness
note: will need to remove right screw to get green ground wire off. And be careful on to damage the gasket.
6) Once Orifice out of refrig, disassemble.
7) Main thing to replace is the Motor DC Evap fan, and maybe CapDust, BumperLid, GrommetEvpFan.
8) now just go in reverse order...
That's it . . . wasn't too hard and NO MORE whining!!! Save at least a couple of hundred by not having a prof. come out and do it. Easy enough for most DIY person.
Read less
Other Parts Used:
Evaporator Fan Grommet - Grey Evaporator Fan With Thermistor Lid Bumper Dust Cap
  • Darren from Renton, WA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Socket set, Wrench set
79 of 111 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Evap Fan was sqeeling
First I removed the shelf and light cover, then removed 3 screws from the ice make. Then I removed 6 screws from the moter cover (back wall of the freezer) and removed it. I then removed the 2 screw holding the moter. This is where the soldering iron comes in. The wire leads from the old motor were molded into a 3" rubber holder and the end wire plastic connector held 6 prongs (2 from a thermo tube). The new motor only held the 4 moter prongs, 2 were empty. To resolve this problem I cut the wires on both the new and old motor. I then attached the old connector to the new moter with the soldering iron and shrink tubing. Replaced all the parts I had removed and started it up. Works like a champ.....
Read less
Other Parts Used:
EVAPORATOR FAN BLADE Evaporator Fan Motor Compression Ring Evaporator Fan Grommet - Grey Lid Bumper Dust Cap
  • David from Raleigh, NC
  • Difficulty Level:
    Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver
41 of 60 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
unit making whining noise
i removed srews from area until i could access the fan unit and removed it. wires were not identical so i had to splice some together, most likely could not have been avoided. the exploded parts diagram helped me to be sure that i would have all replacement parts on hand so i wouldn't have to wait for something i had forgotten.
Other Parts Used:
EVAPORATOR FAN BLADE Evaporator Fan Motor Compression Ring Evaporator Fan Grommet - Grey Lid Bumper Dust Cap
  • timothy from aransas pass, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers, Socket set
11 of 19 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Back to Top
Questions and Answers

Be the first to ask our experts a question about this part!

Back to Top
You May Also Need ?
Lid Bumper
$10.97
$10.97
  In Stock
Evaporator Fan Grommet - Grey
$8.06
$8.06
  In Stock
Evaporator Fan Grommet - Red
$13.21
$13.21
  In Stock
Compression Ring
$9.88
$9.88
  In Stock
Evaporator Fan Motor
$132.03
$132.03
  In Stock
EVAPORATOR FAN BLADE
$72.79
$72.79
  In Stock
Back to Top
Model Cross Reference
This part works with the following models:
PartSelect Number: PS284777
Manufacturer Part Number: WR02X10322
Brand
Model Number
Description
General Electric
31181-1
Refrigerator
General Electric
31191-1
Refrigerator
General Electric
3210-00L0S00-A
Refrigerator
General Electric
3210-00R0S00-A
Refrigerator
Kenmore
36348042894
Refrigerator
Kenmore
36348042896
Refrigerator
Kenmore
36348047894
Refrigerator
Kenmore
36348047896
Refrigerator
Kenmore
36348252894
Refrigerator
Kenmore
36348252896
Refrigerator
Kenmore
36348257894
Refrigerator
Kenmore
36348257896
Refrigerator
Kenmore
36358042894
Refrigerator
Kenmore
36358042896
Refrigerator
Kenmore
36358047894
Refrigerator
Kenmore
36358047896
Refrigerator
Kenmore
36358062894
Refrigerator
Kenmore
36358062896
Refrigerator
Kenmore
36358067894
Refrigerator
Kenmore
36358251894
Refrigerator
Kenmore
36358252894
Refrigerator
Kenmore
36358252896
Refrigerator
Kenmore
36358257894
Refrigerator
Kenmore
36358257896
Refrigerator
Kenmore
36358261894
Refrigerator
Kenmore
36358261896
Refrigerator
Kenmore
36358262894
Refrigerator
Kenmore
36358262896
Refrigerator
Kenmore
36358267894
Refrigerator
Kenmore
36358267896
Refrigerator
Back to Top
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

Contact Customer Service
Dust Cap
$ 16.69
  In Stock
✖
Stock Status
 In Stock

Item is in stock and will ship today if your order is placed before 4:00 PM Eastern Standard Time.

If your order is placed after 4:00 PM EST, the in stock items will ship on the next business day.

 On Order

Item is not in stock and usually ships 3-5 business days from the time you place your order.

 Special Order

Item is not in stock and usually ships 10-15 business days from the time you place your order.

 NLA - No Longer Available

This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.