Bake Element - Push On Terminals - 240V

Hello REnee and thanks for writing. urn off breaker to the oven. Unplug the oven’s plug from the electrical outlet. Open the oven and remove the racks so you can access the back of the oven. Locate the terminals that hold the bad element to the back of the oven. Carefully slightly lift the element and pull towards you . element in place in different areas so check Carefully slide the element out about 4 to 5 inches. Take the old element completely out of the oven. Put the new element into the oven and secure the prongs to the 2 electrical connectors the same way by gently pushing them in Slide the element back into the opening where it secures to the oven back wall. Plug in your oven and turn the ovens electrical breaker to “ON”. Test the oven by putting it on bake mode and check to be sure it is heating properly. The baking element may smoke a little as the manufacturer adds some protective coating to it. Don’t worry as this is normal and the coating will burn off within a few minutes. If test is successful, you have installed the element correctly. Job well done! We hope this helps. Please contact us anytime.

Hi James, Thank you for the question. You will need to remove the back panel from the appliance to access the wire. Hope this helps!

Hello James, Thank you for your inquiry. Yes, it would be advisable to replace the insulation as it protects the inner components of the oven. Hope this helps!

Hello David, Thank you for your inquiry. The terminals measure 3 inches apart. Hope this helps!

Hello Susan, thank you for your question. This Bake Element is 17.25" wide, from side to side at the widest spot, and 15.5" long, from the mounting bracket to the back.

Hello, Thank you for the question. Yes the clips or legs attached to the bottom of the element to hold it up off the floor of the oven are included. The three shipping methods will be listed during the check out. Hope this helps!

Hi Ryan, Thank you for your question. Overtime, the heat produced degrades the insulation in the element and once it wears out the element will start to spark and burn out and it will need to be replaced. I hope this helps. Thank you and have a great day!

Hello George, thank you for your question. Unfortunately, if the part is used or shows signs of installation we are unable to accept it back for resale. Per the model information the bake element PartSelect Number: PS249238 is the correct replacement. If the broil element works, and all other functions on the stove work, except this element that is the most likely issue and will fix the problem when installed. I hope this helps.

Hello Bill and thanks for writing. No, as long as you turned off the breaker you should be ok it is a fairly easy task. For your convenience, we have attached the link to our repair video. We hope this helps. Good luck with your repair https://www.youtube.com/watch?v=7JuJFFInWI4&feature=emb_title

Hello Lori, thank you for writing. The compatible replacement Bake Element for your model range is part number PS249483. If you have an order with our company and need to speak about that, you will have to contact our customer service by phone at 1-888-260-4310, or by email at customerservice@partselect.com. Thank you!