Light Bulb and Socket

After looking up on the computer a schematic of the unit, all that was needed was removing four screws to remove the top and side cover which was one piece.
Next was removal of electrical connection to burned out lamp, then removing burned out lamp and installing the new lamp and reconnecting electrical connection.
Job was complete after reinstalling the cover.

Microwave now working with new lamp lighting when in use.

I happen to have a set of "security" screw driver tips which are required for this appliance - available for about $10 at Home Depot or Harbor Freight. Remove three security screws from back of housing, lift up and aft to remove the cover. The light is on the left in a "snap in" mounting so use a flat blade screw driver to push back the retainer and lift out the old bulb then disconnect the two "push on" wires and install the new light. Total time about 10 minutes. The only issue is the requirement for a security driver set.

removed 3 screws to take off outer housing ( did not have proper screw driver but was able to remove with pliers). used flat head screw driver to pry light socket w/bulb off of snap-in mounting & unplugged socket wire attachments. plugged in & reattached new part.

Went on line and saw the Video - very simple to follow - very easy to remove and install the new switch -- went like a breeze!