Trim Ring - 6 Inch WB31X5013

Oven unit went well and is working. Tilt burner unit was wrong and did not fit. Needs to be replaced by 8 inch tilt burner with four input.

the replacement items fit really good. It was a matter of remove and replace,

Cleaned oven. turned off power at breaker panel. Removed mounting screws and pulled out oven element 4 inches to expose electrical terminals. Removed terminal screws and removed burned out element being careful not to let wires go back into insulation. Reversed procedure to install new oven element. Slid out old trim rings and drip b ... Read more owls after slightly tilting surface elements. Cleaned top of range and installed new rings and bowls. Removed broken timer knobs. New knobs would not push on to the metal shafts until the metal retainers remaining in the slots were pushed out using a small screwdriver.

Just lifted the electric components Remove drip plans and trim rings and replaced with new drip pans and trim. Your company was incredible in there delivery of the parts..One day. You made my husbands very happy.

lift eye slide in bowl and trim ring, put the eye back down,

So this ancient stove we inherited when we bought our house had the drip bowls wrapped in tin foil. We've searched EVERY (not joking) store in our area for drip bowls that would fit it, but apparently Hotpoint wanted to make sure you could never do this - well, at least not easily. No one, not one store carries drip bowls to fit it. I fin ... Read more ally searched online and partselect.com came up first on the list. I was amazed they had the right part! Better yet, ordering was beyond easy, and they came super quick. Popped in the parts in less than 2 minutes, and we're good to go - makes this old stove look new! (well, if this was the 80's, lol) When I clicked on the part it said which stoves it would fit, which was also very helpful. Thank goodness for Part Select! Otherwise we would've had to rewrap those disgusting old bowls... I'd recommend this site in a heartbeat!

Took coil mounting assembly off first, then removed or took apart one piece at a time until heater coil was removed. Then installed (with furnished screws)the new coil, following entire process in reverse. 10-15 minutes time.

It was so easy to find the correct items on your web site and they arrived in a very timely manner. Perfict fit. Now I know how to get parts when I need them.

I just replaced them.

I have tilt up burners on my Range, and decided to replace one that have finally rusted out the part that holds it in place. Repair was easy- installed according to the enclosed instructions. Parts arrived in good condition and very timely. A+