Surface Element - 8 Inch - 2350W

This was about the simplest fix I've ever done. Just pulled off the old surface elements & burner bowls, wiped down the range top, and put in the new parts. Perfect fit. No problems at all. $$ well spent. ParsSelect shipped quickly, and they arrived well packaged. A+ experience all around. Thanks PartSelect. JA, San Ramon, CA

Removed by slightly wiggling out of the coupling. No tools needed, seriously, (and I'm a contractor). Basically, pull out and snap back in.

I removed old 8" surface element and terminal block. Some of old wiring had to be cut off because of harding/cracking of old wiring. Stove was 23 years old and this burner was the most frequently used one. I soldered the new and remaining old wires together. I used the shirnk wrap that came with the terminal block to cover the solder joint. I screwed the new terminal block (one screw holds it in place - used same screw from old terminal block that was removed). I finished by inserting the new surface element. Everything works fine. In the next week or two after we use it a while, I will check wiring again to make sure there are no changes. You need to be very careful as it gets very hot under the burner.

So easy, first I turned off the main switch to the electric. Unscrewed old bake element and screwed in the new one. Worked like a charm. We also bought from Part Select new burners and drip pans. Can't believe how good it looks. I placed my order on a Sunday and received it on Tuesday!! 2 days. Awesome website...Have told everyone about it..THANK YOU PART SELECT..

Unpluged range. Removed back cover to access the infinite switches . removed old burner and drip pan. removed terminal block and retaining screw on cooktop. removed terminal block wiring from infinite switch taking care to mind were the wires came from. Install new terminal block and reattached to cooktop . installed new 8" burner and drip pan reinstalled back panel and plug in electrical to unit . tested burner . replaced stove after verifying burner worked

There was nothing to it...I unplugged the Sufrace Elements from thier bases, removed the Drip Bowls, replaced the Drip Bowls and then plugged the Surface Elements back in to thier bases. The entire process could not have taken more than two minutes.

The burners were not level and would heat more on one side than the other. Since the range was 21 years old and would cost a lot to replace, I decided to replace the burners and
treat myself to new drip bowls. I Googled and got the information on the range including part numbers. I ordered them and am very happy. It was very easy to replace the old ones. Only problem the large drip bowl was dented but on sending an email to compamy, a new one is being sent. I am very happy at the ease since I am a retired widow of 76 years old. It pays some time to take care of the old and do a little reapair instead of spending a lot of money on relacement when every thing else is in excellent condition.
Thanks for making this a very easy experience.

My husband removed all the old terminal block and element, and put the new one in. It was very easy. Thank you for the instructions which were included.

The cause of the problem was that I had installed a generic replacement recepticle earlier. Parts Select had the correct part. It came with handy wire nuts to help connect to range wires to the recepticle wires.

Removed old surface burners and replaced them by plugging in the new surface burners. Now they work GREAT! Parts ordered and received with-in 3 business days. Fed EX delivered parts in good order very quickly. We recommend PartSelect.com