6-Inch Coil Burner Element 318372211

Plugged the new one in and it worked.
I did search out Frigidaire parts and there are other types tha may or may not work. Calrod burners are not all that unusual. I went with the real thing.

I determined that the failure was due to age and wear on the element. Therefore I thought it wise to replace all four burners as a preventative measure. First unplug from power! Replacing the burners was plug-and-play simple. Replacing the switch was easy: Remove the back panel, pull the control knob and remove the two screws securing the switch. Move the terminals to the new switch (one at a time) and mount it with the two screws and replace the back panel. NOTE: The foot bracket on the large burners were about 1/32" too stout and the burner element would not seat in the ring properly. I made a slight adjustment with my grinder and everything fits perfectly.

Pulled out the existing surface elements (4) and inserted the four new ones. New surface elements work great. Heats like a new cooktop stove.

I removed the old burner, drip pan, and burner terminal block. Cut and stripped the wires. I used wire nuts to connect the wires and used shrink tube to secure the nuts. Installed the drip pan and the burner. Hint: When turning the burner on use a vent fan or open windows or doors to get rid of smoke from the new burner.

Unplugged the element and the melted on pot. Plugged in the new element. I thought I might need a whole new cooktop but a new element was very easy to find online.

removed burnt out terminal block, installed new- I soldered wires instead of using wire nuts, took a little extra time, but I feel it's a better connection. I later found that my rotary control must have burnt out too, I swapped it with one from another burner. I'll be ordering a couple rotary controls next from this company. All parts were nice quality. Received quickly.

just unplug stove and unscrewed element out of back wall cleaned up mess and reinstalled. stove top you just pull out bake element and push back in

I just plugged it into the receptacle on the stovetop and turned the thing on, and it worked! I'd been without the 4th burner for quite some time. Nice to have it back!

pull the element out and slide the new element in.No tools needed,it's that easy.

first i removed the two screws that hold the element in place. then pulled out about 3 inches
and disconnected the wires.installed in reverse
order.