Front Burner Igniter/Orifice Assembly 316237805

Hi Earl, Thank you for your question. If the large burner is not lighting, then the issue is likely the spark electrode and you will need to replace the burner base with spark electrode. The part number listed under your model number for the burner base with spark electrode is PS978281. I hope this helps. Thank you and have a great day!

Hi Eduardo, Thank you for your question. If there is only one burner working and the others are not, the issue is likely either the spark module or the wiring harness and you will need to check each part to see which one is causing the issue. I hope this helps. Thank you and have a great day!

Hello Terry, thank you for your question. The burner igniters are included with the orifice assembly for this unit. For the front right burner you would order part number PS2368573 and for the front left burner you would order PS2332710. Please enter the part number into the site for current price and availability. Good luck with your repair!

Good Day George. Thank you for your question in regards to the Front Burner Igniter/Orifice Assembly (PartSelect Number PS2332312). The following are the steps to remove and replace this part: 1) Unplug the appliance before beginning any repair. 2) Shut off gas supply. 3) Remove all of the burner grates, the burner caps and bases and the screws underneath. 4) Insert a putty knife between the main top and the control panel to release the two spring clips. 5) Pull the main top off. 6) Remove wire from the electrode. Use a wrench to remove the old burner tube from the valve. 7) Install new burner tube by screwing it onto the valve, then tighten with the wrench. 8) Attach the wire to the electrode. 9) Slide the main top back on, press down to lock it into place. 10) Align the burner tubes with the holes in the main top and secure with the screws. 11) Replace burner bases by lining up the electrodes with slot or hole in each base. 12) Replace burner caps/grates. 13) And you're done!

Hello Joanne, thank you for your question. The oven has a gas valve and safety valve behind the oven that allows the gas to come in to the oven. The igniter light the gas in the oven, which are PartSelect Number: PS1528534 bake igniter and broil igniter is PartSelect Number: PS1528535. For the top burners, the igniters that light the gas at each burner is only available by ordering the burner/igniter/orifice assembly. I hope this helps.

Hello Sharon, Thank you for contacting us. I have researched the model you have provided and have found the part you’re looking for is Part Number: PS899768. Hope this helps!

Hi Joy, Thank you for your question. If the oven is not heating correctly, then the issue is likely with the oven sensor, sometimes called the oven thermostat or probe, and you will need to check it with a multimeter. When testing the sensor with a multimeter, the sensor should be tested at room temperature. You will need to measure the resistance between the two prongs at the end of the sensor connector. Replace the oven sensor if the reading is less than 900 Ohms or more than 1200 Ohms. The part number for the sensor or probe listed under your model number is PS11731754. I hope this helps. Thank you and have a great day!

Hello John, Thank you for your question. I do apologize however the electrode is only available in the ignitor/orifice assembly. The part number is PS2332692. I hope this helps. Have a nice day!

Hello Ted, thank you for inquiring. It could be this Front Burner Igniter/Orifice Assembly part PS2332312 for your model or the Spark Module part PS2350722.

Hello Daniel, Thank you for the question. This would require the Front Burner Igniter/Orifice Assembly, PartSelect Number PS2332312 to be replaced. Hope this helps!