Range Radiant Element 8 WB30T10132

Hi Doug, Thank you for the question. Before removing the cooktop, you will need to remove the control panel.The control panel contains the control board and burner switches. Remove the screws from bottom securing control panel to vent trim. Next remove the control panel insert by removing the 4 screws. Detach from main harness by unplugging the two connectors. Remove the 5 screws securing the control panel to the maintop assembly. The control panel can now be removed. The cooktop is fastened to the body with two screws. Once they are removed slide the cooktop assembly forward. Lift the cooktop up and off. Hope this helps!

Hello Jaspreet and thank you for writing. We would need to know which burner it is. Left front, rear and so on, then we will be more than happy to find you the correct elements. Looking forward to your reply. We do carry related parts for units just like yours. For example, part number PS11772349. Good luck with your repair.

Hello Simon, Thank you for the question. The Element its self is about 9" not including the connector where the wires attached. The 8" is more for the ring shape on the glass cooktop. We hope this helps!

Hi Howard, Thank you for the question. If the the light will not turn off after the burner that was in use cools down, then you will need to test or replace the burner switch that controls the burner you were using at the time the light became "stuck" on. The switch controls the indicator light and the element. Hope this helps!

Hello Bill, thank you for your question. The most likely issue is the burner switch that regulates the burner. We would recommend testing the switch first before replacing it. The switch sits behind the knob that controls that burner. Here is the testing information. https://www.partselect.com/Range-Stove-Oven+Infinite-Switch-Testing+repair.htm. If the switch is tested and is fine, the issue would be with your element itself. I hope this helps!

Hello Virginia and thanks for writing. You might want to take a closer look if anything is loose or came undone , then it might be just some readjusting . Please be safe and unplug appliances. Hope this help. Please contact us anytime.

Hi Robert, thank you for your question. There are a couple of parts that could cause this issue specifically. You will need a multi meter to be able to test the parts. The first part you will want to check is your radiant element. It should be reading between 0 - 120 ohms to be working correctly. The other part to check would be your infinite (or surface burner) switch. When you remove that part from the appliance, connect each probe from your multi meter to the prongs and then turn the switch to an on position. If you get no continuity then the switch is the issue. I hope that helps. Good luck with your repair.

Hi Melissa, thank you for reaching out. Based on our research, the radiant element you have mentioned is of 2000 watts. We hope this information helps!

Hi Katha, Thank you for the question. First unplug the unit or turn off the breaker. Next raise the top and take note of the terminal labeling before connecting the new part. Might be a good idea to snap a picture before you disconnect terminals. You can also remove one wire at a time and connect it to the terminal on the new part. The old element will be held in by a bracket with one screw. Once the bracket is removed the element should come right off the top. Replace the bracket with the new element. Hope this helps!

Hi Sharon, the manufacturer is showing PS2321566 as the correct part for model JB640DR3WW, you may just be measuring at different points of the element. Thank you for your question and good luck with your repair!