Door Switches and Holder Assembly 99002254

The YouTube video gave me the confidence that I could do the repair and it helped greatly.
One problem with dealing with a 19 year old dishwasher is that the plastic screw supports on the top/front outside cover tend to break off as they are brittle. This is a real problem on reassembly. I used super glue on some of the plastic parts that I could find. The glue job did not always hold. Consequently, the inside cover is a bit loose on the top, but all is working great. We should get a few more years out of this machine, which now works great.
The 2 parts (Computer board and switch handle) should both probably always be put in on the repair, since it is already taken apart.

advisor showed a 30% chance that the part in question would solve my problem and it did. Had help from my 12 year old so it was a great teaching moment. She particularly liked when I forgot a part in final installation and she had to remind me to install before closing up the repair. 15 minutes total. Awesome fun!

Kill power to unit. Lower door. Hold down door and remove inner plastic door cover torx screws, rotate up and use inner door cover to brace outer spring loaded door from closing. lift off metal strap that runs along top edge of door. Unsnap black plastic cover.Latch is under cover. Unplug wires with pliers (they just pull off) after noting where they go. Unscrew single hex head screw and remove latch assembly. inside latch will be reused with the new latch switch holder. Pry up plastic clip keepers and remove inside latch. Depending on age they might break, no big deal you will use the new holder anyway. orient and install switches into holder, install inner latch and install assembly back onto door. Install wires, cover, metal strip and inner door in reverse order. Very easy to do. Parts worked perfect.

Video on website made the repair easy

With watching Video on line it was fairly simply, my son knew exactly what to do, it took him about 20 minutes from start to completion and when tested, dishwasher ran great. We have used it six times and have not had a problem. I would highly recommend this part if you are having the same problem. The video was very good.

Followed the instruction video provided by this site ! 15 minute repair?..Super Simple!!! I Love this company!!! Saved me a bunc of money!!

Door lockout switch bad. Replaced switch assembly

The repair was very easy. I watched a video on youtube to be sure that I was doing it correctly. I consisted of removing 6 or 7 screws, taking off the cover that houses the electronics, removing a screw from the door latch. The wires were then removed from the old switches and placed on the new ones. We then popped the new switches in the new door assembly and reversed our steps. The hardest part was pulling the wires from the old switches. I was not strong enough to pull one of them off and had to have my neighbor come over to help. Other than that, it was a breeze!

I removed the inner door panel and carefully disconnected the wires. Then i removed the switch. I then reversed the process replacing the new switch carefully connecting the wires and securing the switch. Then I connected the inner door panel and everything worked fine.

Turn off circuit breaker to dishwasher.Remove inner door panel by unscrewing 7 screws. Remove metal strip near top of door and black plastic covering. Unscrew single screw with socket screwdriver. Disconnect black switches from wires and lift out old part. Remove handle latch from old part to insert into new part. Connect new black switches to wires and insert switches into holder. Put new assembled part into door. Reassemble all parts that had been removed. Turn on circuit breaker. Run dishwasher!