Light Bulb 316538904

The light and sensor were straight forward and easy. The EOC was as well but there was one glitch. You have to also purchase the black panel overlay, you cannot use the old one. While the adhesive will still adhere, the keypad is different and REQUIRES the new cover. This would have been good to know when I ordered parts as I did not know until I got the three parts and had to reorder the overlay creating a weeks delay in it's repair.

I replaced the bulb using my hands to twist the bulb in the socket located at the top of the refrigerator.

Twisted replacement bulb into place easily. Let there be light!

When the part arrived, I open the box. Cut off my breaker to the range. Pulled back the stove and unscrewed the back. Located the probe, unscrewed the one screw that held it in. I then unclamped the white connectors, remove the old probe, replaced it with the new one reclamped the connectors. Screwed it back into the range. Replaced the back and screwed that back together. It was so easy I was very proud of my self. I cut the breaker back on and cooked a can of biscuits just to see if it really worked. And it did. My bread was not burned, it was cooked to perfection.

replaced it

Easy as 1-2-3

Shut water off, removed back cardboard panel from fridge, disconnect water supply to valve, disconnect electrical plugs to water valve, removed defective valve, cut flexible copper supply tubing as connector was different, connect electrical plugs to new valve, install supplied compression nut & ring onto cut flexible copper supply tubing & re-connect water supply to new inlet valve, attach water inlet valve to fridge frame with supplied screw and added additional self tapping screw through second mounting hole into fridge frame to keep valve from shifting.

First I disconnected the power cord, then removed the screws that held the bracket that holds the base for the water-filer in place. I then disconnected the water lines(intake and outflow). Next I removed the screws that held the water-filter's base in place. I then disconnected the release lock mechanism for the filter and finally removed the water-filter base. I did the reverse to install the new water-filter base. Previously I had tested the intake water line and noticed the water was flowing with enough pressure upto the water-filter's base but no water was exiting thru the outflow line, which leads to the Ice-Maker and Dispenser. I had tried changing the filter but that didn't solve the problem it was then I had realized that the Base was the problem. The actual problem was the spring-loaded valves for both the intake and outflow lines, which had a plastic prong that protrudes out of the base that is triggered by the filter when installed. The two prongs were worn-down so the filter wasn't activating the spring-loaded release valve to let the water thru. As for the light, I just unscrewed it.

Filter housing assembly removes easily. Two screws removed prior to removing water connections. Replace water connections prior to screwing new assembly into place. Original support studes were old and shattered - easy to remove (careful not to crack the side wall of the fridge when trying to remove). Ensure pin is removed from new support studs prior to installing on side. Once in place, insert pins flush to ensure studs in place.

The parts supplied were made to fit. The hardest part was getting the original broken tabs out of the internal walls of the fridge with out damaging the internal insulation. I punched the center locking pin through completely, dug out the broken tabs and then reached into the hole with a dental pick and pulled out the center pin. The new parts fit perfectly and with a plastic mallet, tapped the new locking pin into place.