MODULE-DISPENSER 240563639

Hello Rose, thank you for your inquiry. We only sell OEM original parts and the part PS12728800 is compatible to your model LFSS2612TF2. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.

Hello Leary, thank you for your question. The second one down from the top is FIX430122. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.

Hello Armando, thank you for getting in touch. To replace the dispenser module, you need to remove the drip tray first. Next, use a Phillips-head screwdriver to unthread the screws securing the front dispenser panel. Slide the panel up to detach it, then disconnect the wire connector. Using the Phillips head screwdriver or a number two square drive bit, unthread the screws securing the module. Slide out the dispenser waterline and disconnect the wire connector to fully release the old assembly. To install the new dispenser module, you should increase the slack in the water dispenser line. To do this, detach the lower grille and use a 7/16-inch wrench to depress the retaining ring to release the water line from the coupler. Push the line up through the door to increase the slack. Now insert the end of the dispenser water line through the hole in the module and connect the wire connector. Fully position the module and thread the screws to secure it. Reinstall the front panel by first connecting the wire connector, aligning the tabs with the slots in the door, and sliding it down. Re-thread the lower screws, replace the drip tray, and insert the end of the water line into the coupler until fully seated. Finally, realign the grill and snap it into place. Plug the power cord back in, and your refrigerator should be ready for use. We hope this helps, good luck with this repair!