Waveguide Cover

Hello Steve, Thank you for your inquiry. Part number W11087199 would be the part that is compatible to your model. The hold can be caused by moisture or food getting into that area, or that the magnetron may be failing. You can test the magnetron with a multimeter to see if it has continuity-for safety reasons, make sure you discharge your capacitor first. Hope this helps!

Hi Jeremy, Thank you for your question. Yes, this would be the correct part you are looking for. It is a wave guide cover. I hope this helps. Thank you and have a great day!

Hi Jonathan, this seems like a common problem, sadly I could not find any preventative measures. Thank you for your question and good luck with your repair!

Hi Joe, Thank you for your inquiry. Replacing a microwave oven wave guide cover is a relatively simple task. That said, the process does vary from model to model. Here are the two most common ways to remove a microwave wave guide cover: Many wave guide covers are held in place with either a single screw or several screws. Remove the screw(s), and then slip the cover out of its housing. Other models require that you remove the entire outer cabinet of the microwave before you can remove the wave guide cover. In these models, the wave guide cover is most often secured to the internal right hand wall. With the outer cabinet removed, examine the right side of the unit. You should see where the wave guide cover secures in place. You will likely need to push down on the top of cover's clips to release it. Then reach inside the microwave and pull the cover out of the bottom slots. Refer to your microwave owner's manual if neither of these processes apply to you. I hope this helps. Thank you and have a great day!

Hi Rafael, thank you for contacting us. The microwave oven can cause sparking due to damage in the waveguide cover, part number PS12070624. This waveguide cover protects the waveguide channel from debris and food splatters. You need to replace this part to fix the issue. We hope this information is useful!

Hello Daryle, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS11769950.We hope this helps, good luck with this repair!

Hi Teresa, Thank you for your question. The glass trays for for most microwaves are made out of tempered glass. In some cases, stress points may occur in the glass as a result of extreme heat from the bag of popcorn caused by continuous cooking of it or if the popcorn is stale and does not pop. This can cause the glass to break. For some brands of popcorn, it is recommended to place the bag of popcorn on a microwaveable plate before placing it in the microwave. For more information you will need to consult the instructions on the bag of popcorn before heating it in the microwave. I hope this helps. Thank you and have a great day!