Refrigerator Handle set (2 pieces) - White 5304506469

Very simple. Remove the 2 top screws on the door, slide the lower part of the handel on to the lower screw on door .,swing the handle up to the top of he door and attach with the 2 original screws. DONE

It was extremely easy. I opened door, unscrewed the two (2) screws at the top of the door handle with a phillips screw driver. Once screws were out I rotated the handle to the left and unhooked it from the mounting block. The new handle was already equipped with a mounting block. I attached the new handles mounting block to the door and rotated the handle up and positioned the holes to the holes on the door. I used the same 2 screws from the old handle and tightened them into the handle and door. That was it. Very easy.

Parts arrived, my son brought the box into the home we first had to take all the food and stuff out of the fridge washed her down made the inside and outside look brand new. (1st) piece replace was the Door Gasket, I couldn't find a flat head screw driver so I used a butter knife and popped out the old Door Gasket cleaned away any gook and grim (Use a mister Clean Magic Eraser) They do a fantastic job. and also they get into those deep hard to reach areas. pop the new one in and that was that. New Door Gasket went right in. The (2nd) Door Retainer bars. they pop off really easy you can hit them with the bottom of you hand and they com right off, got one correct. had to switch the other two around as the door didn't close at first than door closed without a problem in fact it came with an extra (Door Retainer Bar) one so thanks the fridge has an extra should one break. (3rd) the crisper and fresh baskets. scrubs the heck out of the shelf and the glass. those look brand new. and then when dry put everything in added the baskets to were they go fridge looks brand new and we have gotten a whole new skill set. this was a very easy project to do and it was a lot of fun. I hope your will go as smoothly.

I simply loosened the screws holding the refrigerator door handle and then slid the bottom portion of the handle off from the screw holding it in place. The bottom portion of the handle did not exactly marry-up with door, showing a very small gap. I attributed this to the age of the appliance.

Open door and use a screwdriver to remove screws. SAVE the screws because the new handles do not come with screws. Rotate broken handle to the left and slide the handle to the left which should slide the handle off of the screw protruding from fridge door. To install new handle, repeat this process in reverse. Rotate new handle up and screw onto fridge door.

Easy replacement, I did add some glue to improve hold. The new handle design was a little different and did not match freezer door so I had to change both. I guess that's why they sell as pair.

remove old handle,screw the new one.

The repair was very easy to do. All I did was slip the bottom part of the new handle over the Phillips screw on the refrigerator door. Then I put the top part of the handle in place on the top of the refrigerator door. I put the 2 Phillip screws back in the top part of the handle with a Phillips screw driver.

It took less than 15 minutes to replace the old cracked handle with a new one. In the future if I need anymore parts, I will be ordering from your company again. I am happy with my order and the great service I got from the staff at Part Select. Thank you, Sandy McClaflin

Removed the two top screws, removed handle, put on new handle, replaced screws.

Followed instructions