Refrigerator Handle set (2 pieces) - White

remove screws at top of lower door, replaced with new handle very easy to do.

The lower attachment of the handle needs to be put on first with the top of the handle pointing to the left of the door. Then the top part can be swung in place and screwed on easily

Open refrigerator door to gain access to top door handle mounting screws. Remove two screws at top of the handle on the refrigerator door. Slide handle up to release the bottom mount. The handle is now removed. The bottom screw remains in the door. To install the handle slide the mount onto the bottom screw and check the fit. If the fit is loose screw it in clockwise and check the fit again. Adjust the screw until the bottom fits flush with the door face. Align the top two mounting screws and snug them up. Close the door and align the bottom handle with the top handle. Open the door and do a final tighten on the top two screws. Be careful not to over tighten because you can crack it.

Removed screws. Rotate door handle, and slide it off anchor screw. Slide new door handle on anchor screw, and rotate door handle into position. Replace screws.

Slipped the new handle right on and tightened the screws, removed broken support rail and easily put the new one in its.place,tightened the screw and it was done

Took old handle off . Then slipped new one on bottem in place @ top placed screws in place .Very easy .

Unscrewed old part. 2 screws. Screwed on new part. Viola!! Easy peasy! Quickest and most convenient repair ever!

Parts arrived, my son brought the box into the home we first had to take all the food and stuff out of the fridge washed her down made the inside and outside look brand new. (1st) piece replace was the Door Gasket, I couldn't find a flat head screw driver so I used a butter knife and popped out the old Door Gasket cleaned away any gook and grim (Use a mister Clean Magic Eraser) They do a fantastic job. and also they get into those deep hard to reach areas. pop the new one in and that was that. New Door Gasket went right in. The (2nd) Door Retainer bars. they pop off really easy you can hit them with the bottom of you hand and they com right off, got one correct. had to switch the other two around as the door didn't close at first than door closed without a problem in fact it came with an extra (Door Retainer Bar) one so thanks the fridge has an extra should one break. (3rd) the crisper and fresh baskets. scrubs the heck out of the shelf and the glass. those look brand new. and then when dry put everything in added the baskets to were they go fridge looks brand new and we have gotten a whole new skill set. this was a very easy project to do and it was a lot of fun. I hope your will go as smoothly.

It was easy to remove the broken handle and install the new on. Only thing needed was a screw driver.

two screws out, two screws in.