Element with Limiter 6 Inch - 1200W W10823711

Easy to install by my friend the electrician. Probably could have done it myself.

The part was correct. But the old part had two connections, and the new had 4. I don't like experimenting with electricity. Putting a small instruction paper within would be helpful..

Replacing the element went well and works great. I had to change one connection as the new element was a little different than the old one. It had a large spade where the original had a small spade. Other than that it only took about a half hour to fix.

The existing leads did not fit the replacement, but extensions were shipped with the element that modified the wiring to easily work.

Part was a newer revision requiring a small wiring modification. Still pretty straight forward with wires supplied.

The element shipped wasn't the same one in the picture. The one in the picture was identical to the one I was replacing. The Black wire on one side wouldn't connect to the unit as the male end was wider. Whirlpool sent two wires but the male/female ends were either both wide or narrow. What I needed was a wide female end and small male end to make it work. Off to Lowes.

thanks!

Part came in good condition and the stove burner is now working. Took a little extra time to identify the correct terminals to attach wires. They were in different positions. The instructions did explain this, but took reading it a few times to make sure I was correct. Moving the light over from one to the other and the mounting tabs were not covered, or very little. There was no new hole for that screw, and I wasn't sure it would easily screw into the new base. It did though, wish there was a note on this. I also found too parts on the order page that I wasn't exactly sure which was correct. I think I have ordered the correct unit. No photo on the second unit so I couldn't tell by that. The part numbers noted in the details did not correspond with anything I had found on the old hardware.

I bought the heating element to replace a non-working one for a Maytag stove, ad said genuine but it was not, heating element shown in picture is not exactly the same as original, but it fit and worked, first I installed the same way the old one was wired up, heating element will lit up non-stop without limiter, after further review, I notice some marks at each of the studs that are hard to read on the white ceramic, I follow this marks, match it with the marks of the old set up, had to use one of the included adapters to extend wiring to one of the studs, then it works fine, element heat up, then the limiter kick-in and heat up again. Part shipped without installation instructions, hope they fix this in the future. Would highly recommend to take a picture before you start removing the old heating element or do a schematic of studs: 1a, 2a. 1b. and 2b, for a frustration free install;

Excellent service, good parts.