Dishwasher Filter W10872845

Hello Jim, Thanks for your question. Unplug the dishwasher. Open the dishwasher door. Reach in and pull out the lower rack until it is resting on the door, and then remove it and set it aside. Push down on the filter and twist it counterclockwise. Turn the filter until it stops moving, with the tabs released. Pull the filter out of the dishwasher. Put the new filter in by setting it into the opening, possibly turn it a bit. Then turn it clockwise to lock it in. Put the lower rack back in by setting it on the door and sliding it in. Close the door, plug in the dishwasher again. I hope this helps.

Hello Mike, Thank you for your inquiry. We would recommend checking the following parts to fix your issue: drain hoses, drain pump, filter, the sump and also make sure that there are no clogs where the water drains into the sink/disposal. Check for any obstructions around the pump and sump system, and also clean the filter. Hope this helps!

Hi Mike, Thank you for the question. The filter is located under the lower spray arm. Hope this helps!

Hello Terry, thank you for inquiring. This is most likely due to a faulty Inlet Valve, part number PS12578165 for your model. You may also want to consider the Overfill Control Switch, part number PS11750031. Good luck with your repair!

Hello Glenn, thank you for your question. We would recommend cleaning the spray arms, and manifold tube, as well as the filter under the lower spray arm. It would be a good idea to run a mixture of water and vinegar or a dishwasher cleaning solution. That should help take care of the smell. If it does not, you may have to disassemble the unit some, and clean the discharge tubes, and sump. I hope this helps!

Hello Gary, Thank you for your inquiry. Anywhere around 1 cup of water leftover after a cycle is normal. It's there to keep the seals from drying up and your dishwasher will pump it out immediately before you get started on a new load. However, if it does not, you may want to check your drain pump and drain hoses. Hope this helps.

Hello Steve, thank you for inquiring. This is caused by a block or clog in the drain path. This could be the Sump, Pump, or Drain Hose. From what you have mentioned, you will most likely need to replace the Sump, part number PS2329328 for your model dishwasher. Good luck with your repair!

Hi Beverly, Thank you for your question. There is a screen filter listed under your model number. The part number for it is PS11753602. I hope this helps. Thank you and have a great day!

Hello Jim, Thank you for your inquiry. I would test the circulation pump and motor assembly as this is what forces the water up through the spray arm to clean the dishes, if any one part of it is not working, the lower spray arm won't turn. You can test it with a multimeter. Hope this helps!

Hi Lewis, thank you for your question. It is likely a build up of debris from the wash and depending on how hard your water is that could also be the cause of something like that. I hope that helps. Good luck with your repair.