This gasket wraps around the sides and top of the dishwasher door and helps seal the door when it is closed to prevent water from leaking from the dishwasher during the washing cycle. If your dishwasher is leaking water, first inspect the seal for food particles near the bottom and sides, and remove it. A buildup can stop the door from closing properly and keeping a tight seal. Check the door gasket for tears, cuts, or wear. If the gasket is damaged, you will need to replace it. Before starting the repair, make sure to disconnect the power to the dishwasher.
Ask our experts a question about this part and we'll get back to you as soon as possible!
7 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Yvette
November 2, 2017
My dishwasher is leaking and water running out from under the door and onto the bottom panel all across the door big puddles help
For model number DU930PWSS0
Hi Yvette, Thank you for the question. I suggest checking the door gasket to see if there is any damage. There is the seal that runs along the top and sides of the door and one that runs across the bottom. The bottom seal is only sold as part of the door frame. Hope this helps!
13 people found this helpful.
Was this helpful?
Thank you for voting!
Ashley
May 17, 2019
How do i know if this the problem to my leak??
For model number DU600PWKQ0
Hello Ashley, thank you for your question. If the door is leaking around the edges or corners of the door this could be the cause of the leak. If your dishwasher is leaking water, first inspect the seal for food particles near the bottom and sides, and remove it. A buildup can stop the door from closing properly and keeping a tight seal. Check the door gasket for tears, cuts, or wear. I hope this helps!
3 people found this helpful.
Was this helpful?
Thank you for voting!
Bob
February 10, 2020
Replacing gasket-it is about an inch and a half to long on each side and the bottom hangs out?
For model number DU620PWK00
Hi Bob, thank you for your question. We might suggest double checking the installation. We have a video here: https://youtu.be/3sA8N32CBg0. If you still have a little left over that will be alright as long as it does not impede with your door shutting closed. Good luck with your repair.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Zhipeng
February 14, 2022
my dishwasher is leaking from top of door. I don't know if it is sealer issue. Does this part fit my dishwasher? thanks
For model number DUB50DWGQ1
Hi Zhipeng,
Thank you for your question. Yes, this would be the correct door gasket for your dishwasher. If you would like to place an order for it, customer service is open 7 days a week and anyone will be happy to assist you. Please feel free to give us a call. We look forward to hearing from you!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Paul
April 28, 2022
Just got my new dishwasher door gasket and it's longer than the old one should I just measure the old 1 and cut the new 1
For model number 66515795791
Hello Paul, thank you for your question. We would recommend installing the part first and if it is still too long, some may be cut off. We hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
James
December 6, 2022
I replaced the door gasket with one I bought from Partselect but my dishwasher is still leaking from the bottom right side. Ay idea what I should do to fix this problem.
Thanks
Jim
For model number 66515719000
Hi James, thank you for reaching out. According to our research, we would suggest replacing the Water Deflector, part number PS11746099. The Water Deflector attaches to the front lower corner of the tub to prevent water from leaking through the door. If that does not help, we would suggest checking the Pump Gasket, part number PS384950. If you need help placing an order for it, please feel free to give us a call. We look forward to hearing from you!
PS11755809. Does this gasket will fit on my Inglis IJU58660?
For model number IJU58660
Hi Laurent,
Thank you for your question. The part number listed under your model number for the door gasket is PS11755809. If you would like to place an order for it, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Part Videos
Replacing your Whirlpool Dishwasher Dishwasher Door Gasket - Gray
Customer Repair Stories
Average Repair Rating: 4.4 / 5.0, 34 reviews.
What's this?
< Prev
1
2
3
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
dish washer leaking out bottom of door
New gasket did not fix problem. Cleaned air vent cover for steam to exit. Gasket not the problem but new one looks good. thank you
Ed from Ulysses, KS
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
DOOR leaking
door gasket old the vent was pluged up full of black slime cleaned out and door stopped leaking
mike from SHELTON, WA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
NEW GASKET
I USED A PLUMBER
George from TEMECULA, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
leaking suds and water front bottom of door
Replaced door gasget took 5 minutes tops. Ran cycle and still had leak. Called local repair person. After thoroughly checking out the dishwasher and running soapless cycle determined problem to be soap build up over time. He ran a commercial cleaner through a complete pots and pan cycle. No more suds and no more leak repair complete. Did not actually need door gagset but it was super easy to change and delivery service was great.
Wayne from Peru, IN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
5 of 7 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water was dripping out of the front of the unit down low.
I removed the old gasket, installed the new one which took about 20 seconds.Tested the unit, water was still dripping, but in a different fashion.As per a previous poster's instructions I removed the vent cover. (Located inside the dishwasher up high.)I cleaned out the calcium deposits with hot water and a sacraficial toothbrush. "Ta-Da!" Everything is now groovy!Thank you so very much for your excellent service. Your site was easy to use and your shipping was "lightning fast!" Also, the advice you sent me was invaluable. I thank you, my wife thanks you and my trained lobster thanks you too! :)
Phil from atascadero, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
80 of 86 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dish Washer was leaking every once and a while. Shield came out and was deformed by heatinfg eliment and was found on the bottom of the unit.
The gasket was a breeze, with just pulling out the old one and slowly pushing in the new in the track with my fingers. The shield was a little harder since there was no instructions before me. It turns out that it fits in the inner door and is used as a baffel for the steam (another problem with leaking out the bottom). After removing the front cosmetic pannel you need to thread the shield inside on three tabs that hold it. It took a few times to orientate it properly but it snaps in when correct. After the front pannel was put on and the unit test operated, the washer no longer leaks. Highly recommend the parts and help from PartSelect and the others before me.
This was an easy fix. My husband took out the old gasket and put the new one in. It fit perfectly and no more leak. The part got to us really quickly too and that was nice. No more hand washing the dishes! :)
Carolyn from Keithville, LA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
0 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
dishwasher leaks from left side of door
The old gasket came out easily, but had calcium deposits in area. I cleaned the area with vinegar and water and waited until it was completely dry. The new gasket went in very easily and looked great. I started the dishwasher and alas, it still leaks, so the problem was apparently not with the gasket, but some other area. But the gasket is nice and new. Any suggestions on next step0 in troubleshooting?
Catherine from Holbrook, AZ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
10 of 14 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water leaking from front door of dishwasher
Took less than 5 minutes. Pried edge of old door seal out with a flathead screwdriver, then slowly pulled out old seal. Thoroughly cleaned area for new seal with rubbing alcohol, inserted new seal and trimmed the end to fit just right. Presto, no leaks whatsoever!
Gregory from North Port, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
1 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water intake hose leaked between plastic/hose connection (metal crimped clamp)
Since I had never made a repair on this 14 year old Kitchen Aid dishwasher, it was "discover as you go." First turned it on its back, took off bottom, disconnected both hoses and found out that hoses would not move. So, had to take off top and remove the back/side unit to get to hoses on top side where they were fastened by tape and a hose holder. Replaced hoses, used old clamp and "buttoned" it up.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
James R P - September 8, 2022
Verified Purchase
30 second repair .
Send to me by mail very quickly.
★★★★★
★★★★★
Robert D - June 8, 2022
Verified Purchase
No more leaks
I paid more to get a genuine OEM replacement part so I would not end up like the persons who purchased the Chinese knock offs and it worked perfectly. A tip on assembling in my Kenmore dishwasher, You tube videos will instruct to install at the middle length distance of the aligned with the top center of the door width. However, I discovered on my model that the bottom right of the door has a positive stop and this should be the staring point as the left bottom does not. This will take the guess work out of the installation process and save removing and trying to restart the seal in the middle multiple times. The washer door will be harder to close due to the new seal thickness but will return to normal in a couple of weeks. No leaks. A kitchen floor costs a lot more than good dish washer door seal.
★★★★★
★★★★★
Clara M - March 21, 2022
Verified Purchase
Gasket
Very easy to install
★★★★★
★★★★★
Moire B - March 10, 2022
Verified Purchase
Easy fix
The part came relatively quickly. We were able to make the repair ourselves and saved a lot of money. Praise God!!!
★★★★★
★★★★★
Diane S - February 27, 2022
Verified Purchase
Perfect fit
I appreciated the video. I never changed a gasket before. Dishwasher doesnt leak anymore. Doing the repair by myself saved a huge bill.
★★★★★
★★★★★
James L S - February 11, 2022
Verified Purchase
Easy repair
Just followed video instruction. Repair was finished in just minutes. No more leak!
★★★★★
★★★★★
CHAD R - November 14, 2021
Verified Purchase
DISHWASHER DOOR GASKET
CORRECT PART AND FIT GOOD NO COMPLAINT ABOUT THE PART.
MY ONLY SUGGESTION IS PEOPLE WOULD LIKE PARTS IN A TIMELY MATTER SO YOU MIGHT WANT TO SWITCH TO UPS FOR DELIVERY.
★★★★★
★★★★★
Frankie M - May 22, 2021
Verified Purchase
Fast shipping. Just as advertised
Arrived quickly. Video on the site made installation very easy.
★★★★★
★★★★★
Tony C - November 1, 2020
Verified Purchase
Repair.
It worked perfectly ...five minute installation. Thank you.
★★★★★
★★★★★
WAYNE E - October 28, 2020
Verified Purchase
installed easily
The dishwasher was old but still works great. But it leaked water. After a thorough inspection to rule out possible causes I determined the door gasket had lost some of it's softness. I've used PartSelect many times in the past and they have always come through with the correct part, usually OEM, at a fair price. Using PartSelect saves me money and time because I don't have to purchase the part locally, wait to be ordered and pay a much higher price.
< Prev
1
2
3
Next >
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11755809
Manufacturer Part Number: WPW10509257
With the Fix app, you can quickly and easily find information on your appliance, along with videos and articles to help you fix it.
"Like magic. I took a picture of the model number on my refrigerator, and the app identified it right away … Very convenient. I'm impressed." ★★★★★ - Clever Jeff
★★★★★
You added 1 item to your cart
✖
$
Qty:
Total item(s) in cart:
Order Subtotal
$
*Taxes and shipping will be applied during checkout
Your Subscriptions
Same-day Shipping
Ships from USA
1 Year Warranty
365 Day Returns
