Front Load Washer Bellow Door Boot Seal - Gray

9 year old washer started leaking - after inspecting noticed a large hole in the bellow.
The only difficult part was putting the outside band clamp on over the bellow without it slipping out of place - took a few tries. The video was very helpful - I did put hardware into plastic bags based on the steps in the removal for so that I wouldn't forget (or get them mixed up).
I was able to do this project while home from work with a sick kindergartener. Problem started and did the removal the first day ordered the part and it arrived 2 days later - install complete in less than an hour. We went back to school/work with a operating washer by the end of the week! Thank you - it was actually kinda fun and my son bragged to his grandfather that 'he and momma fixed the washer'.

Unplug, remove top and bottom panels using nut driver.
The control panel also must be removed; mine just snapped loose, providing access to the top hex-head screws securing the front panel/door assembly. The gasket/bellows is secured to the front panel and tub with circular clamps. The front panel clamp, a wire loop held tight with a spring, must be removed prior to taking off the front panel/door. I used a wide blade flat head screwdriver to pry it off. The door assembly is rather heavy and awkward as the door swings randomly once removed. It may be helpful to secure it to the frame with duct tape prior to removal. Six screws, three top and three bottom, secure the panel. Once removed, there is access to the clamp securing the back of the bellows to the tub. This one is a larger loop with a screw type tensioner. After removing it, the old gasket can be pulled out.
These gaskets have drainage holes at the bottom which must be in line with the drain hole on the tub. Clean the grooved edge where the gasket sits. It fits inside a channel on the bellows. It’s a snug fit and it helps to lubricate the bellow’s channel with liquid soap. Once it is in place, make sure it’s seated properly-there’s a groove that accepts the clamp-and the drainage holes are positioned over the drain at the tub’s bottom. Replace the clamp in its channel and tighten it with a nut driver or screwdriver.
Replace the front panel/door. Next, clean the channel on the front panel and work the front of the bellows into it’s place on the panel. The sprung front clamp can be difficult.
There are spreader tools made for the job, but I just used two needle-nose pliers to stretch the spring. After the new bellows is installed, reassemble the cabinet. I left the bottom panel off until I ran a test cycle to check for leaks.

I followed the instructions in the video (available on the site) and had no problem whatsoever to replace the boot. This video is so detailed that it is difficult to go wrong.
Only caution I would make is that this may prove to be a bit too much if the person has never ever used tools before.