Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
April 30, 2018
When replacing the motor control unit can it be accessed from the rear or is the easiest access via the front panel... my front panel is one whole piece not a two piece set up..
For model number WFW94HE
Thank you for your question. To access the motor control board, you will need to remove the back panel to gain access to it. It should be down on the bottom left corner. I hope this helps. Thank you and have a great day!
12 people found this helpful.
Was this helpful?
Thank you for voting!
July 11, 2019
The washer starts a selected cycle and shows remaking minutes but does nothing. A code F0 E0 appeared one time, but can not see this code again.
For model number WFW97HEXL2
Hello Shane, Thank you for the question. The F0 E0 normally indicates an issue with the boards communication. I suggest unplugging the appliance and opening up the control panel. Disconnect all the connectors and making sure there is no damage and then reconnecting them all securely. After the appliance it plugged back in and if the same issues occur, you may have a defective board. Hope this helps!