Part Location Diagram of WPW10304342 Whirlpool Water Level Switch
See part 20 in the diagram
( Grid squares measure 1x1 inch )
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

customerservice@partselect.com

Water Level Switch WPW10304342

Rated by 1 customer 

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

$ 109.88
  In Stock
Get FREE EconoShip on orders over $100! T&C apply

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

PartSelect Number PS11752436
Manufacturer Part Number WPW10304342
Manufactured by Whirlpool
Troubleshooting
This part works with the following products:
Washer.
This part works with the following products:
Whirlpool, Maytag.
Part# WPW10304342 replaces these:
AP6019132, W10304342
Back to Top
Customer Repair Stories
 Average Repair Rating: 3.3 / 5.0, 1 reviews. What's this?
Sort by:
  • 1
Sorry, we couldn't find any existing installation instruction that matched.
FO8 and EO3 fault codes. See your manual.
To replace the water level switch is easy, remove the three screws in the rear, slide top back a couple of inches, lift cover off. Rear upper right corner is the switch. Remove small hose to switch, twist switch 90* and pull out, disconnect two connectors, reverse procedure to install new switch. This did not fix the code problem tho. To get to the pump filter is not very difficult but time consuming. Disconnect the power cord. Remove the soap dispenser, then the two screws behind it, then two screws for the front control panel, then four screws on the bottom of the front cover, back out but leave in the three screws on top of front cover, two screws holding the door lock and switch, careful with that, wires are short and difficult to plug back in, remove water spout from drum seal , lift out the bottom of front cover, the seal holds it in, reach in lying on the floor, the filter is in the center, make sure the washer is empty or water will run out, unscrew filter. I found a fabric eyeglass holder and a $1.94 in coin. This tells me the seal to drum is to far away. Reverse procedure to put back together. I will never buy another front loading Washer again. They don't appear to get enough water to really do a good wash job no matter what cycle you use. If you should pull the seal off close to the drum , it's difficult to fasten back on again.
  • William from DELPHOS, OH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

Be the first to ask our experts a question about this part!

You May Also Need ?
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11752436
Manufacturer Part Number: WPW10304342
Brand
Model Number
Description
Whirlpool
BNQ11C6ANA0
Washer
Whirlpool
BNQ11CVANA0
Washer
Maytag
MHW6000XG0
Washer - WASHER
Maytag
MHW6000XG1
Washer - AUTOMATIC WASHER
Maytag
MHW6000XG2
Washer - AUTOMATIC WASHER
Maytag
MHW6000XR0
Washer - WASHER
Maytag
MHW6000XR1
Washer - AUTOMATIC WASHER
Maytag
MHW6000XR2
Washer - AUTOMATIC WASHER
Maytag
MHW6000XW0
Washer - WASHER
Maytag
MHW6000XW1
Washer - AUTOMATIC WASHER
Maytag
MHW6000XW2
Washer - AUTOMATIC WASHER
Whirlpool
WFW94HEXL0
Washer - Residential
Whirlpool
WFW94HEXL1
Washer - Residential, Automatic
Whirlpool
WFW94HEXL2
Washer - Residential, Automatic
Whirlpool
WFW94HEXR0
Washer - Residential
Whirlpool
WFW94HEXR1
Washer - Residential, Automatic
Whirlpool
WFW94HEXR2
Washer - Residential, Automatic
Whirlpool
WFW94HEXW0
Washer - Residential
Whirlpool
WFW94HEXW1
Washer - Residential, Automatic
Whirlpool
WFW94HEXW2
Washer - Residential, Automatic
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

Contact Customer Service