Electronic Control Board WPW10285178

Some buttons of my diswasher don't work including the 'start' button. I am not sure if i have to replace the control panel or the control board. Please guide me.

Hello, my dishwasher has no response from the buttons on the control panel. I checked the door switch and the bi-metal fuse with a multi meter and they have continuity. If I unplug the ribbon cable from the control board going to the control panel and reconnect it only the cancel light will illuminate. If the door switch is then closed the drain pump will try to run until the start or cancel button is pressed. None of the other buttons will light up or start a cycle. Do I need to replace both the control panel and control board? Thanks, Tom

We recently had a power outage which blew out a few electronic items. The dishwasher stopped working: No lights on the panel at all. I changed the bimetallic thermal fuse but noticed a capacitor on control board had lost its cover. Assume control board needs to be replaced. How difficult is it? Do you have a video as useful as the thermal fuse one?

The dishwasher will run for at least 2 hours if not manually stopped. Will this control board fix this problem ? Or do I need another part? Thanks

My Kenmore he4 will not auto sense dryness and turn off...it runs until the clock times out..i have already replaced the moisture sensor strips..

My dishwasher drains after each cycle except for the last cycle where the water stays in the machine. The pump works fine, the hoses are not clogged. Is there any other part I should look before I change out the electronic control board wpw10285178 which unfortunately is out of stock at this time

I believe this is the part i need. My dishwasher runs fine; except it won't drain at the end of the cycle. It will completely drain if i push the cancel button at the end of the cycle, so it does not appear to be a clog in the drain pipe. Is that a part that a homeowner can install or do the wires need to be soldered?

It will fill with water, not wash then drain the water and then do it again like its running but the dishwasher never washes. Is that the control board or the pump!

Hi, my jdb3600awp5 dishwasher doesn't run.I see the lights on but when i try to run any cycle nothing happens. When i first close the door i hear it draining ,but thats all that happens. I changed the censor with the 2 leads, no change.

The console of my dishwasher currently has 4 cycles very dimly lit that remain on continuously. When i press/hold cancel, they do not shut off. I made sure the control lock button on the console was not illuminated. I disconnected washer from power at the circuit breaker two different times for 1 minute each to attempt to get the unit to power cycle and reset. This did not resolve the issue. Washer will not allow me to select any button (will not illuminate to show that the button has been pressed), and those four buttons remain very dimly lit continuously. When closing the washer, the pump engages for about 5 minutes and then all activity stops. The dishwasher is currently non-functional. I am unsure if i need to replace the console, control panel, control board, or the door latch--or a different part. Any suggestions?