Torsion Spring

I didn't have to buy a new Ice door kit. The part on the Refrig. door I needed I found out was unavailable. The door parts (Ice door parts and the asembly for the water unit) screws into that part. I found out that I would have to replace the whole refrig. door which was $900.00. I took every apart got me some pvc glue used it on the door and bought the original screw online with some other assorted parts,Door switch, etc. and was able to repair in about an hour. Some of the parts are very fraigle so you have to be very careful or you will be buying some new replacement parts.The new nickel and dime parts are expensive. My Icemaker was leaking where the Ice was clumping together in the bin, and when I checked the unit was $125.00. I found a new one and replaced it for about half that price. I am now very happy! (a least until the next project.)

Unpluged the unit and removed the front trim ring.
removed the old parts and installed the new parts.
in reverse order. it took about 12 hour but the dispenser to work but seems to work fine now.

I started by using some superglue to reattach the broken mounting ring for the pin above the ice door flap. Wait a few minutes for the glue to set (I waited about 2 hours.) After that, install the pin and spring with the spring legs facing the door flap mount and the arch on top. Angle it so the freezer door apply pressure to the spring arch then slot the pin into the circular mount you just glued on the left and the retaining slot on the right.