Control Panel with Touchpad - Stainless/Black

Hi Tom, Thank you for the question. The ribbon cable wire harness should just pull off the control panel. Grip end side of the connector and pull out. Hope this helps!

Hi Kay, Thank you for your question. We do not have information specifically for this model on how to replace the control panel, but here are some installation instructions on how to replace a burner switch that may help. It involves removing the control panel to access the switch. Unplug the oven from the electrical outlet. Remove the four screws under control panel. Remove the old burner knob and loosen the old burner control. Lower control panel from the range. Remove the 5 wire connectors from old burner control with pliers. Remove the 2 screws that held burner control to the range panel. These are Torx head screws. Install new burner control. Replace the two screws to burner control. Replace the 5 wire connectors to new burner control. Replace the 4 screws under the panel. Replace the knob to new burner control. Restore power to the oven and it should now work for you. If you require more information there are videos on YouTube that you may reference or you will need to contact the manufacturer. We hope this helps. Thank you and have a great day!

Hello Tim, thank you for contacting us. We have researched the model you have provided and have found that the part you are looking for is the control panel, part number PS11750321. This control panel includes the touchpad and it houses the selection buttons and display components for the range. Please reach out to customer service if you need help placing an order. Glad to be of help!

Hi Tim, thank you for your question. That may be the part that would be the issue. Especially if you have changed your control board itself. You could do a quick check on all of the other parts. Test your elements with a multi meter to see if they are working correctly or not. They should be reading between 0 - 50 ohms to be working correctly. The other part you should check would be your oven temperature sensor. That can also be tested with a multi meter and should be reading between 1000 - 1100 ohms. However if all of those parts are find then it is likely your panel that was the issue. Good luck with your repair.

Hello J, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS11750323 for the Black Panel. The Stainless and White options are both discontinued. We hope this helps!