This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Will Not Start | Fridge too warm | Freezer section too warm | Clicking sound
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
7 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Perry
September 28, 2017
Compressor kicks on for 2 seconds and cuts back off. About a minute later, it kicks back on and continues to repeat the cycle. Replaced the overload on the compressor, checked the thermostat (okay), circulation fan below and in the freezer are both running. Is something else in the circuit or do i need a new compressor?
For model number ED5VHEXVQ03
Hi Perry,
Thank you for your question. I would suggest also checking your run capacitor as well. If it is not that part, it could be your electronic control board that is the issue. Unfortunately that part would have to be tested by a technician. Good luck with your repair.
8 people found this helpful.
Was this helpful?
Thank you for voting!
Charbel
September 25, 2019
Hi which parts replace start device on my refrigerator old part number is " eecon 213615000" thank you
For model number GD2SHAXMQ00
Hello Charbel, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS11749877. This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures. Hope this helps!
4 people found this helpful.
Was this helpful?
Thank you for voting!
Lori
November 23, 2019
Can i test start relay and overload combination part to see if its the problem why my compressor cuts off and wont restart?
For model number ed5fhaxvs01
Hello Lori and thanks for writing.
Insert the multi-tester with one probe on each of the "s" and "m" terminals. Set the tester to zero ohms. Turn over the relay and after a clicking sound, the reading should change to "infinity" if the relay is functioning. Turn the unit over again and place one probe from the "s" terminal to the "L" terminal. We hope this helps. Please contact us anytime.
4 people found this helpful.
Was this helpful?
Thank you for voting!
Reynaldo
October 19, 2021
Blessings and hello. Do u think I have a bad relay and overload combo because it was change with the compressor, but only bottom of fridge and freezer was only cold, then evaporator motor was change and the fridge and freezer was cold for a week and then went warm, defrost thermostat was change still nothing, what could it be? Help me please
For model number ED2KHAXVQ01
Hello Reynaldo, Thank you for the question. If the Relay and Overload were already replaced and the appliance is cooling in the freezer and bottom of the Fresh Food Section, they should be fine. We suggest checking the Air Diffuser Assembly at the top inside of the Fresh Food Section. It leads to the Freezer and should open and close to allow cold air through. We hope this helps!
Hello again, the fridge and freezer are both warm now, the air is still coming out the diffuser and the evaporator fan motor is blowing warm air again.
For model number ED2KHAXVQ01
Hello Reynaldo, Thank you for the question. This could indicate the Thermostat to control the temperature is defective. We hope this helps!
MY RERIGERATOR IS WARM ON THE FREEZER SIDE AND THE REFRIGERATOR SIDE COULD START DEVICE BE BAD PS11740258
For model number ED5GVEXVD02
Hello Carl, thank you for writing. There are 3 main parts to look at when the temperature is too warm for the Fridge and Freezer. The first is Capacitor PartSelect Number PS11757023. The Bi-Metal Defrost Thermostat PartSelect Number PS11750673. The Thermostat Assembly PartSelect Number PS11739232. All three parts have installation videos on our site. We hope to hear from you soon.
If I replace the compressor with the Maytag compressor kit do I need refrigerant as well or does it already have it in the compressor?
For model number MFD2560HES
Hello Rocco, thank you for contacting us. The compressor does not have refrigerant and you are going to need it because before replacing the compressor the refrigerant needs to be removed completely. Please note that replacing the compressor involves many technicalities and should be performed by a qualified professional. The compressor, part number PS2580803, is compatible with your model. We hope this is what you were looking for. Please reach out to customer service if you need help placing an order.
Average Repair Rating: 4.0 / 5.0, 6 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Our Refrigerator and freezer stopped working
I had read on a fix it site that the start device for the compressor on this particular model was known to fail after 3-5 years. When we received the part it looked like something that just plugged into the compressor. My husband unscrewed the panel in the back of the fridge and saw the part on the compressor. He first removed the three wires that it was connected to, and the wires were inside a plug so all he had to do was remove the plug from the start device. He then removed the old start device from the compressor. Plugged in the wire plug into the new start device, and pushed in the new start device into the compressor. There was also another black part plugged into the old start device that he plugged inot the new start device that connected to the compressor. Our freezer and refrigerator starting working. Within a couple of hours our freezer had made ice.
Anna from Lincoln, RI
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
58 of 68 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refrigerator not cooling, water dripping from doors
Water was dripping out of top freezer door and had water under the refridgerator. I could hear a clicking noice from bottom of refrigerator every 3-5 minutes. After removing back panel, I noticed the fan was running and the clicking seemed to be coming from somewhere around the compressor which was warm. I noticed on the site a simular problem had been submitted. It said to remove the start relay and if it rattled it was bad. I removed two wires from it ( it is connected onto the side of the compressor) then took a small screw driver to pry it away from the compressor. It not only rattled but had tiny pieces falling out. I ordered the part and replaced it in less than 15 minutes total and all is well.
Darrell from Hammond, LA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
20 of 23 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
stopped cooling,the compressor would come on and shut back off.
pull the fridge out away from the wall and hope you have a long flex water supply hose.remove cardboard cover,oh yea unplug fridge first.unplug wire from the relay.flip the wire retainer off the relay and pry it away from the compressor.pull the 2 prong capacitor off and then reverse the steps to reasemble. skip the middle man at the local appliance shop.i waited 2 weeks for him to get the part and gave up.your reg shipping got it here in 2 days.
william from shady dale, GA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
15 of 18 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
not getting cold
The relay and overload went in easy. Too bad that wasn't the problem. I needed a new compressor. Cost - about $500
unplugged the power and removed the cardboard back Unplugged the part and power from the side of the compressor Plugged the power and new part back in to the side of the compressor and replaced the clamp Plugged in the power cord to the wall outlet and the refrigerator started to hum Job done Thanks
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Ralph P - September 30, 2020
Verified Purchase
VERY EASY TO LOCATE AND DIAGNOSE AND REMOVE
I RECEIVED THE PART AND IT WAS EXACTLY THE SAME AS THE OLD ONE,I INSTALLED IT IN 5 MINUTES, MY FRIG. IS WORKING PERFECTLY NOW
★★★★★
★★★★★
Doug M - July 30, 2020
Verified Purchase
Good supplier
Got my correct part sooner than estimated. Worked great. Easy purchase
★★★★★
★★★★★
Keli F - November 18, 2019
Verified Purchase
Works Great!
Now I have an extra frig! Good thing I did not listen to the repair person and give away my old frig. Sure my compressor is "bad" if the parts leading up to it have a problem! This fixed my Whirlpool side by side 10yr old frig. Thanks!
★★★★★
★★★★★
Robert C - June 14, 2019
Verified Purchase
Recent easy repair
Just remove the old parts hannam put in a new parts is perfect identical to the parsa replace except they were good
★★★★★
★★★★★
Diana B - December 9, 2018
Verified Purchase
Worked great
My refrigerator works again.
★★★★★
★★★★★
Amy Z - June 20, 2018
Verified Purchase
Worked like a charm
Easy to install and fixed the loud clicking that drove my dog bonkers.
★★★★★
★★★★★
Alan H - March 1, 2018
Verified Purchase
easy fix! thanks!
Your web site was exactly what I needed to get my refrigerator fixed. Ordered the part; it came in and 15 minutes later the fridge was up and running.
★★★★★
★★★★★
Michael M - January 24, 2018
Verified Purchase
relay overload combo
I thought I would get the overload relay and starting capacitor as a combo. I did not get the starting capacitor with this part(the more expensive part of the combo} As there is no image available for this part number Im not sure if I was purposely misled or the capacitor was just accidentally left out.
The Fix App makes it easy to manage all your stuff in one place. Just snap a photo and we'll find and store your user manuals, receipts, and product information in one easy-to-find place!
"Like magic. I took a picture of the model number on my refrigerator, and the app identified it right away … Very convenient. I'm impressed." ★★★★★ - Clever Jeff
