Part Location Diagram of WPW10136934 Whirlpool Belt
See part 30 in the diagram
( Grid squares measure 1x1 inch )
Customer Service Representative

Get in touch, we're here to help!

Open until 12am EST

customerservice@partselect.com

Belt WPW10136934

★★★★★
★★★★★
2 Reviews

Rated by 2 customers 

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

$ 61.32
  In Stock

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

PartSelect Number PS11748884
Manufacturer Part Number WPW10136934
Manufactured by Whirlpool
Troubleshooting
This part fixes the following symptoms:
Noisy
This part works with the following products:
Dryer.
This part works with the following products:
Maytag, Whirlpool.
Part# WPW10136934 replaces these:
AP6015603, W10136934
Back to Top
Customer Reviews
Average Rating:
★★★★★
★★★★★
2 Reviews
5.0
Filter By Rating:
  • 5 Stars
    2
  • 4 Stars
    0
  • 3 Stars
    0
  • 2 Stars
    0
  • 1 Star
    0
Sort by:
  • 1
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
  • 1
Customer Repair Stories
 Average Repair Rating: 3.3 / 5.0, 2 reviews. What's this?
Sort by:
  • 1
Sorry, we couldn't find any existing installation instruction that matched.
Squel with heavy load
Well before ordering parts. I removed back panel with screw gun to locate issue noise. The I applied a real quilty spray lube to the tensioner an spun it a few times. Then put dryer back together and ordered parts. I'm waiting for the noise to return before I actually make the repair. Old saying if it's not broke don't fix it.
Other Parts Used:
Idler Pulley Wheel and Arm Belt
  • Matt from SAINT LOUIS, MO
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
metal rubbing sound at drum edge: found seal cut and idler bearing frozen
Getting the cabinet open is always fun. Prying the top open without breaking the clips. I took a small pry bar, covered the end with gray tape and found the the clips located on the front outer edges. You push in on the metal clips from the front and lift the top off the plastic alignment dowels. Remove the back, and two front panels. Removed the drum and vacuumed out everything (inspect). Remove old seal, idler pulley assembly from back of dryer (spring & bolt & note belt routing). Glue new felt seal on drum, slide on drive belt, bolt on new idler assembly & attach spring. Attach lower inner front panel screws. Flex out front panel and lower in the drum (make sure the felt seal lip is not folded over). Complete installing front panels. Slide belt towards center of drum (see old mark). Flex idler assembly and route drive belt. Hand spin drum to align belt. Plug in and run dryer briefly to confirm things run smoothly. Align lid clips and close. Unplug and attach back panel and vent hose. ALL DONE.
Other Parts Used:
Idler Pulley Wheel and Arm Belt SEAL
  • GARY from CEDAR CITY, UT
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers, Socket set
8 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

Ask our experts a question about this part and we'll get back to you as soon as possible!

5 questions answered by our experts.
Sort by:
  • 1
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Leroy
February 17, 2018
How do replace this part
PartSelect logo
Hello Leroy, Thank you for your inquiry. Lift up the lint screen cover to access the two screws, if you have the type of lint screen that has the cover built into it, just pull it out and remove the screws. Using a putty knife, insert it under the top about two inches from each corner to release the locking tabs, make sure you are going above the two bottom tabs in the release mechanism to hit the center release. Lift up the top and use a flat blade screwdriver to release the clip of the door switch. Using a 5/16 inch nut driver, remove the screws that hold the front panel on. Lift it up then pull the panel out to pull it off the latches at the bottom. In order to get the belt off the motor pulley, press the pulley towards the outside of the dryer, then take the belt off the pulley. Once it is off the pulley, you can pull it off the drum and put the new one on. Make sure the belt has no kinks or twists in it, then slide it onto the drum, sliding it back to the original position. Lift up on the idler pulley and push it towards the side of the machine, then create a loop in the belt, which you can pull over the motor pulley. Put the front panel back on by lining it onto the latches on either side and pushing down, lift the drum and line it to the front of the panel and re-attach the screws. Reconnect the door switch, press the top back into place on the locking tabs and replace the screws. Hope this helps!

2 people found this helpful.

Was this helpful?
Thank you for voting!
Tim
December 19, 2019
I have a noise, took idler pulley off the belt, belt looks ok, but I cannot get tension on the belt now.
For model number MEDB400VQ1
PartSelect logo
Hi Tim, Thank you for your question. If the belt is not getting any tension, there may be an issue with the idler pulley and you will need to either adjust it or replace it. We hope this helps. Thank you and have a great day!

2 people found this helpful.

Was this helpful?
Thank you for voting!
James
January 16, 2023
Will this belt work?
For model number MEDB725BWO bravo XL
PartSelect logo
Hello James, thank you for your question. The Blower Belt is part PS11746333. This Belt measures 23.9" Long. The Dryer Drum Belt is part PS11748884. This Belt measures approximately 95 inches Long .Good Luck and have a great day.

1 person found this helpful.

Was this helpful?
Thank you for voting!
James
January 16, 2023
how can I find a drum belt for this dryer
For model number MEDB725BWO XL
PartSelect logo
Hi James, thank you for asking. This dryer drum belt, part number PS11748884, fits your model. If you require assistance to place an order, please contact customer service. We hope that helps!

Was this helpful?
Thank you for voting!
James
January 16, 2023
You did not tell me if this belt will fit this dryer
For model number MEDB725BWO bravo XL
PartSelect logo
Hello James, thank you for writing. Yes, the part WPW10136934 is the same as PS11748884 which fits your model. Good Luck and have a great day.

Was this helpful?
Thank you for voting!
  • 1
You May Also Need ?
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11748884
Manufacturer Part Number: WPW10136934
Brand
Model Number
Description
Maytag
7MMGDB850WL0
Dryer - GAS DRYER
Maytag
7MMGDB850WL1
Dryer - 27" GAS DRYER
Maytag
7MMGDB950AG0
Dryer - 27" Gas Dryer
Maytag
7MMGDB950AG1
Dryer - 27" GAS DRYER
Maytag
MEDB200VQ0
Dryer - RESIDENTIAL DRYER
Maytag
MEDB200VQ1
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB400VQ0
Dryer - RESIDENTIAL DRYER
Maytag
MEDB400VQ1
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB700BW0
Dryer - DRYER
Maytag
MEDB700VQ0
Dryer - RESIDENTIAL DRYER
Maytag
MEDB725BW0
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB750YW0
Dryer - 27 Inch Electric Dryer
Maytag
MEDB750YW1
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB750YW2
Dryer - 27 Inch Electric Dryer
Maytag
MEDB800VB0
Dryer - RESIDENTIAL DRYER
Maytag
MEDB800VQ0
Dryer - RESIDENTIAL DRYER
Maytag
MEDB800VU0
Dryer - RESIDENTIAL DRYER
Maytag
MEDB850WB0
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850WB1
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850WL0
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850WL1
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850WQ0
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850WQ1
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850WR0
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850WR1
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850YG0
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850YG1
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850YG2
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850YW0
Dryer - 27" ELECTRIC DRYER
Maytag
MEDB850YW1
Dryer - 27" ELECTRIC DRYER
Customer Service Representative

Get in touch, we're here to help!

Open until 1am EST

Contact Customer Service