Electronic Control Board WPW10084142

Hi Ron, Thank you for the question. The fuses and relays are built into the board, so the full board will need to be replaced.Hope this helps!

Hi Serafin, Thank you for the question. I suggest testing the Bi-Metal Fuse,PartSelect Number PS2360984. Use a multimeter to test the fuse for continuity and replace it if it is not showing continuity. Hope this helps!

Hello Al, Thank you for your inquiry. We would recommend checking the following parts to fix your issue: door switch, heating element, bi-metal fuse, high limit thermostat, and electronic control board. You can test the parts with a multimeter. You should get a reading of between 5 and 30 ohms on the heater if it’s good and less than one ohm on the high limit thermostat and fuse. I have included a link to our article on how to test the door switch. Hope this helps! https://www.partselect.com/Dishwasher+test-door-switch+repair.htm

Hi Bob, Thank you for your question. You would start at P1. There are some appliances that this particular board goes to that has more pins, that is whey there is extra on the end. I hope that helps. Good luck with your repair.

Hi Frank, thank you for your question. You may have to take a look at your door switches. If those parts are not working it will believe that your door is open and so no power will connect to the control board. You can test those switches with a multi meter. They should be testing 0 ohms. If you are not sure how to use a multi meter we have a tutorial here: https://www.youtube.com/watch?v=bWC44fHn0As. Good luck with your repair.

Bonjour Francine, merci d'avoir écrit. Ce tableau de commande électronique est le remplacement approprié pour votre modèle. Vous voudrez peut-être commencer par examiner la partie PS11743423 relative au thermostat de limite supérieure ou la partie élément chauffant PS11748194. Nous espérons que cela aide.

Hi Vickie, thank you for your question. According to our research, you may need to check the control panel, part number PS11741388. If this is not causing the issue, we recommend you replace the control board, part number PS11748221. Good luck with your repair!

Hello Bobby and thanks for writing. We would be happy to do some research to find you the correct parts. However, we need your model number and the brand name to locate any information on this. Model numbers can be short or long and could have a mixture of numbers and letters. We do carry related parts for units just like yours. For example, part number PS11745496 Good luck with your repair.

Hi Jesse, Thank you for your question. If you replaced control panel on the dishwasher and you still have no power to it, you may need to check the electronic control board and the door latch with switches. We hope this helps! If you have any questions, please let us know.

Hi Roger, Thank you for your question. If a light on the dishwasher panel is blinking and the cycle will not advance, there may be an issue with either the door latch and switches, the heating element, the water inlet valve, the pump, the control panel or the electronic control board. You will need to inspect and test these parts to see which one is causing the issue. Sometimes a film may build up on the on the end of the control panel ribbon cable that attaches to the electronic control board which may prevent the dishwasher from working correctly. This film may be removed by gently using an eraser to rub it off. We hope this helps! If you have any questions, please let us know.