Replacing your KitchenAid Wall Oven Convection Element
Troubleshooting
This part works with the following products:
Wall Oven, Range, Microwave Oven Combo.
This part works with the following products:
KitchenAid, Whirlpool, Maytag, General Electric.
Part# WP9760769 replaces these:
AP6014068, 4448841, 4452157, 9758525, 9760769
Customer Repair Stories
Average Repair Rating: 3.8 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Not heating up properly
Installed a new thermostat and noticed the convection heating element wire had burned in two. Ordered new element and installed. Oven is currently working properly again.
Harmon from MONTICELLO, GA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
1 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
John
November 21, 2017
Oven won't heat up all the way. Sometimes it will heat up but once you open the door it will not heat back up to set temperature. Than sometimes it will work for days before it acts up. Help please
For model number KDRP463LSS08
Hi John,
Thank you for your question. I would suggest testing your element and your temperature sensor inside of your appliance first. You can test both of those parts with a multi meter to check. If both of those parts are fine, it may be your oven control that is the issue. I hope that helps. Good luck with your repair.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Theresa
September 5, 2019
Serial # xu3907578
My double wall oven takes almost 25 minutes to preheat with no food in it. Is this normal? If not, what could be wrong with it?
For model number KEBS207SSS00
Hello Theresa, Thank you for the question. I suggest testing the Temperature Sensor, PartSelect Number PS11748765. Testing the temperature sensor probe on your oven is easy. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. Hope this helps!
