V-Style Cogged Tooth Pump Belt WP95405

Hi Andy, Thank you for the question. First turn off water. Disconnect electrical supply and water hoses. Remove agitator and cap. Lay machine on it's front. Do not leave it over night on it's front as some oil will leak out the breather hole on top of the transmission.Remove rear service panel. Loosen both nuts holding the motor mounting bracket in the base plate.Rotate the motor to the right to relieve the belt tension and remove belt from motor pulley.After belt is removed, rotate the motor to the left as far as possible to assure cam bar clearance.The spin cam bar must be advanced to the spin position. You can do this by pushing up on the spin control solenoid plunger and rotate the main drive pulley until the cam bar advances to the spin position.Remove the brake spring from the gear case cover and yoke.Remove the 3 support braces attached to the gear case and base plate.Remove the 2 pump mounting bolts. The pump hoses do not have to be removed.Remove the gear case mounting stud and spacer. Loosen the remaining 2 gear case mounting studs.Remove yoke retainer from yoke support. The gear case can now be pulled down so that the belt can be removed out between the top of of the clutch shaft and the clutch yoke, hen through the space under the stud. Drop the belt from around the gear case.Reverse the procedure in steps to install the new belt. Replace the pump making sure the pump lever is engaged in the slot in the agitator cam bar before securing the pump to the gear case. Grasp the bottom loop of the yoke spring with a pair of pliers and insert the spring in the hole in the upper gear case cover. Replace spacer in short gear case mounting stud. Finger tighten the 3 gear case mounting bolts . Set the machine upright and tighten the gear case mounting bolts securely. This procedure will allow the structure to align itself with the center post bearing. Lay the machine on it's front to mount the 3 support braces to the gear case base plate and tighten the bolts securely. To adjust the belt tension properly, position the belt over the pulleys. Insert a hammer handle or something similar between the motor mounting brackets. Rotate the motor as far as it will go to the left. Tighten the motor mounting bracket nuts. Check the tension of the belt, it should be about 1/2 inch.Set machine upright. Reinstall the agitator,service panel and water supply and plug the appliance back into the outlet. Good luck with the repair!

Hi Jean, thank you for your question. Yes, it looks like your old part number updates to this part so it should work. I hope that helps. Good luck with your repair.