Light, Indicator (Surface Unit WP8523265

Hi Tim, Thank you for your inquiry. Yes I believe that this part would be the right replacement to fix that problem. However I would suggest testing it with a multi-meter first. Just to be sure that this is the part that you need to replace. Good luck!

Hi Barbara, Thank you for your inquiry. It sounds like one of the burner switches may have a shorted contact inside it and you will need to test the continuity of each switch with a multimeter. I hope this helps. Thank you and have a great day!

Hi Sue, Thank you for your question. You will need to replace the light indicator switch. The part number listed under your model number for it is PS11746053. I hope this helps. Thank you and have a great day!

Hello Raj, Thank you for the question. The lenses is just a plastic cover for the light. We would recommend replacing the indicator light. Hope this helps!

Hi Barney, thank you for your question. Be sure to cut power to your appliance and remove any parts before doing tests. There are a couple of parts that could cause this issue specifically. You will need a multi meter to be able to test the parts. The first part you will want to check is your element. It should be reading between 0 - 50 ohms to be working correctly. You may also want to double check the light indicator itself and perhaps the wiring, just make sure the part is working and it is wired up correctly. The last part to check would be your infinite (or surface burner) switch. When you remove that part from the appliance, connect each probe from your multi meter to the prongs and then turn the switch to an on position. If you get no continuity then the switch is the issue. It could also be your wiring that is the issue but you should see visual damage on that part in most cases. I hope that helps. Good luck with your repair.