Water Inlet Valve WP8182862

Hi Paul, Thank you for your question. If there is water leaking into the tub when the washer is not in use, then there is an issue with the water inlet valve and it may need to be replaced. I hope this helps. Thank you and have a great day!

Hi Ken, Thank you for your inquiry. The F20 error code is letting you know that there is a water supply issue. To resolve this issue press pause/cancel 2 times. If this does not help unplug the washer from the electrical outlet for 2 minutes and plug it back in. Try a wash cycle and if the F20 error code appears again you will need to open both the hot and cold water valves all the way to see if this fixes the issue. Also make certain the hoses are connected correctly and that there are no obstructions in them. Also clean the filters on the water inlet valve. If you have tried all this and it does not help you may need to replace the water inlet valve. I hope this helps. Thank you and have a great day!

Hi Bill, Thank you for the question. Yes, if it is just the cold water that is not filling properly then the valve will need to be replaced. The valve has a cold and hot solenoid and the cold side sounds like it is not opening to allow the water through. Hope this helps!

Hi Greg, Thank you for your question. Yes, this is the correct part for your model. Good luck with your repair.

Hi Albert, Thank you for the question. Most Frequent Causes for the FH error is no water entering the dishwasher. The most common part to cause this is the Flowmeter. Hope this helps!

Hello Lorri, Thank you for your inquiry. We would recommend checking the following parts to fix your issue: Water inlet valve, Water Level/Pressure Switch, Flowmeter, and Water Level Pressure Switch Hose. Also check the inlet hoses for any restrictions or blocked screens. Hope this helps!

Hello Staci, thank you for writing. For this symptom you will want to consider either the Water Inlet Valve part PS11745050, the Flowmeter part PS11748313, or the Water Level/Pressure Switch part PS11755855. We hope this helps.

Hi Neil. This is most likely a faulty inlet valve. Thank you for your question and good luck with your repair.

Hi Nnam, Thank you for your question. If the washer control does not sense water coming into the washer within 30 seconds of the fill valves opening, the FH error code will appear. Resetting the washer may remove the code. If your washer has a pause/cancel button, press it twice to cancel the wash cycle and then unplug it. With the washer unplugged, check the inlet hoses to see if the screens are clogged and check the both the hot and cold water water inlet hoses to see if they are kinked. You should also check the drain hose to make sure it is not down too far in the stand pipe. Also, make sure that the faucets are completely turned on. Once you have done this, plug the washer back in and select a wash cycle. If the FH error code reappears, then depending on your model, you may have an issue with the pressure switch, the sensor, the wiring or the electronic control board. We hope this helps! If you have any questions, please let us know.

Hi Terry, Thank you for contacting us and for letting us know. We are happy to hear that you were able to resolve this issue. Sometimes clothing can get stuck in the grooves of the bellow or door boot seal and cause this problem. It is important to clean and check the bellow regularly for signs of wear or damage. If you have any questions, please let us know.