Broil Igniter WP8054129

Hi Bill, Thank you for the question. The sounds you here is the spark module.Soudns like you may need to replace the igniter.Even if it glows it might not produce enough ohms to igniter the gas. Hope this helps!

Hi Bart, Thank you for your question. The oven has a broil ignter, a bake burner electrode, a gas valve and a spark module. You will need to check these parts to see which one is causing the issue. I hope this helps. Thank you and have a great day!

Hello Brenda, thank you for your question. The most likely issue is the sensor part number PS11748765. Measure the oven temperature sensor resistance using a volt/ohm meter. If the resistance isn’t 1080 ohms at room temperature (70 degrees F), replace the oven temperature sensor. If the sensor is tested and is not faulty, the issue could be the igniter itself, or the oven control board. I would recommend starting with the sensor, as the oven is lighting, but sounds like its not sensing properly which is the most common symptom of the sensor. I hope this helps!

Hi Bobby, Thank you for your question. The E0-F2 error code is letting you know that the there is a stuck keypad on your electronic oven control. Sometimes dried food or liquid residue can cause a keypad to get stuck. Try and press any key on the touchpad. Only press it once and do not hold for any length of time, sometimes pressing a keypad button for longer than 3 seconds can cause this code to appear. Take a clean cloth and and wipe any residue off the touchpad. Then either unplug the oven or turn the circuit breaker off for 30 seconds. Restore power after 30 seconds and it should work. If not, you may will need to replace the touchpad or the electronic control board. I hope this helps. Thank you and have a great day!

Hi John, Thank you for the question. To get to the valve you will need to remove the bottom storage/broiler drawer.Hope this helps!

Hello Ken, thank you for your question. We would recommend testing the sensor, Part Number: WPW10181986 first. Testing the temperature sensor probe on your oven is easy. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. If the sensor is fine, we would recommend replacing the igniter. It could be that the igniter is getting to temp, but failing to remain there throughout the cooking process. Good luck with your repair!

Hi David, thank you for your question. There are a few parts that could cause this issue in your appliance. First I would say test your igniters with a multi meter to see if they are working correctly or not. They should be reading between 0 - 1100 ohms to be working correctly. The other part you should check would be your oven temperature sensor. That can also be tested with a multi meter and should be reading between 1000 - 1100 ohms. If those three parts are fine however, then the issue may be in your control board or the spark module. I hope that helps. Good luck with your repair.

Hello Curtis, thank you for asking! Some parts that we recommend inspecting are the Bake (bottom) Igniter or the Broil (top) Igniter. You should also inspect the Gas Valve as well as the Spark Module. I would also suggest checking your oven burner tubes for debris as well. If any of these parts show signs of defect or damage, they should be replaced. I hope this helps!

Hi Hank, Thank you for the question. If it is just when baking I suggest replacing the Bake Igniter, PartSelect Number: PS11747275. Hope this helps!

Hello Kenneth, Thanks for your question. Remove the racks from the oven after unplugging the range. Unlock and remove the pan in the bottom of the oven cavity. You may need to remove your oven door to get access. There is a baffle to remove by unscrewing it, and you will see the broil igniter, which can be unbolted and then pulled out. Be sure to notate the wiring prior to installation. I hope this helps.