Timer - 60Hz WP661649

Hi Mark, Thank you for your question. If your timer is not advancing past a certain point, then the timer is one part you will need to check. I would advise doing a load of clothes on a different setting to see if the timer advances all the way. If it does then you will need to replace the timer. There are some other parts that you will also need to check to see which one is causing the issue. You will need to check the lid switch assembly, the direct drive motor coupling, the direct drive water pump, the timer dial, the knob spring clip and the water inlet valve. I hope this helps. Thank you and have a great day!

Hi Ronald, Thank you for your inquiry. Before beginning any repair please unplug the appliance from the electrical outlet. Push in the timer dial and turn it counter clockwise and take it right off. Grab the dial and pull it right off. Unscrew the 2 timer holding screws. Remove the twin cams and holding screws and remove the control panel. Remove the wiring harness from the timer and remove the old timer. Connect the wire harness to the new timer. put the timer in place and lower the control panel and put the control panel back in place. Screw in the 2 holding screws. Put the dial and the knob back on. Secure the control panel with the screws. I hope this helps. Thank you and have a great day!

Hi Robert, Thank you for your question. Yes, this is the correct timer for your appliance. Good luck with your repair.

Hi Branden, Thank you for your inquiry. To verify if the problem is the timer or the lid switch, you will need to use a multimeter to check the continuity of each part. Also, to verify if it is the timer, you can try it on a different setting than what you normally choose to see if the timer will advance. If it advances on a different setting then the issue is with the timer. I hope this helps. Thank you and have a great day!