This is an ejector arm, and it is used in conjunction with your refrigerator. The function of this part is to act as a cube ejector inside your ice maker. The arm will rotate inside the ice maker to allow the ice cubes to fall out of the marker and into the ice bucket. This part is made entirely of plastic, is white in color, and has eight teeth. It measures just over 9 inches long, and one and a half inches wide. To make this installation the tools you will need include a quarter-inch nut driver, a flat-head screwdriver, and a Phillips screwdriver.
Average Repair Rating: 5.0 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Ice maker ejector arm broke into.
Removed old ejector arm and installed new part.
Mary L. from Millsboro,, DE
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
16 of 46 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kelly
July 31, 2017
The ejector arm came off and we cannot figure out how to install it back.
For model number kssc48qms02
Hi Kelly,
Thank you for your question. You must first remove the ice bin and the shelf that is directly above the ice maker to give yourself room to maneuver inside of your freezer.
Then, with a flat head screw driver, release the locking clip on your wire harness so that you can take your ice maker out of the freezer.
You must remove the white ice maker cap. Then using your flat head screw driver, push out your electrical connection. After that you can remove your dispenser arm just by pulling it out of the slots it is in.
Unscrew the control module. There are three screws that keep that on. After that, remove the black plastic housing as well. Gently remove your black plastic housing.
Once you have gotten your ice maker apart, you can simply slide your injector back into position. After that, you just repeat these steps backwards to get your ice maker back into place.
I hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
