Compression Nut

Hello Ron, Thank you for your inquiry. We have researched your model and the part you need would be PS11742367, which is the water line connector that is 1/4" into 5/16". Hope this helps.

Hi Harry, Thank you for your question. Here are some instructions that a customer posted on how they installed the door chute, "First I unplugped the refrigerator, then I removed the drip shelf (slides out). Then removed the two screws hidden by the drip shelf. Then I removed the control panel by pulling out on the bottom then lifting slightly to to expose the ribbon cable. The circuit boards you see at this point will deliver an electrical shock if the refrigerator is plugged in. I disconnected the ribbon cable form the control (front) panel. Next I removed three screws that hold the chute assembly in place and worked the chute away from the door. Pay attention to the placement of the water line before you remove the chute. The bad flap fell out at this point but it is easy to figure out how to place the new one. When putting the chute back in place make sure the arm holding the flap is aligned in the groove of the solenoid plunger and not just setting on top. (I had to do this twice because the chute would not open the first time I put it back together). About a 30 min job because I took it apart the first time to see what was broken. I only needed the flap, the arm it mounts to an the solenoid were not broken. Easy to do and only cost about $16.00 with shipping for the part." We hope this helps! If you have any questions, please let us know. We are open 7 days a week. We look forward to hearing from you!